August SE10 Portable CD and MP3 Player User Manual

SE10 Portable CD and MP3 Player
User Manual

Thank you for purchasing August SE I 013 Portable CD & MP3 Player. This user manual is designed to familiarize you with all the features of this device. Please take the time to read this user manual carefully, even if you are already familiar with a similar product.

Safety
To ensure the safety of you and others, please read the Safety Instructions before using this device. Please do not disassemble the SE10B, it can be unsafe and will invalidate the manufacturer’s warranty.

Disposal
Please ensure the product and accessories are disposed of in compliance with the WEEE (Waste Electrical and Electronic Equipment) Directive and any other regulations applicable to your country. Always check with the environmental agency and any other relevant authorities for current disposal regulations.

Declaration of Conformity
The Declaration of Conformity can be found on our website at http://augustint.com/en/declaration/

Customer Service
You can contact us by phone on: +44(0)845 250 0586 or by email at: service@augustint.com should you require further technical support or customer service.

Safety Instructions

Storage and Use

Maintenance
Please unplug all leads before cleaning this device.

Main Features

• Stereo Speaker & 3.5mm Audio Jack
• Equalizer with 5 Sound Modes
• Adjustable Playback Speed
• Built-in Rechargeable Battery
• Anti-Skip Protection

Box Contents

Part Names and Functions

Operation

Power
Charging:
You can use any charger that supports USB 2.0.
It will take around 4 hours to fully charge the player. When the battery is being charged, the LED indicator will be red. Once the player has fully charged, the LED indicator will turn green. 

Power On:
The power switch is located on the side. Please toggle it to ON. When a disc has played to the end or there is no disc, the SE10OB will enter a standby mode after 20 seconds.  Please press the PLAY button again to restart the player.

Power Off:
There are two ways to tum off the player:

1. Please toggle the power switch to the OFF position if the player will no longer be used for a long time;
2. The player will enter a standby mode by pressing the STOP button.
   Note: Please turn the power switch to OFF after use.
   

Music Source
CD:
Push the OPEN button to the right to open the door. Insert your index finger into the center hole of the disc and take the edge of the disc with your thumb. Insert the disc upwards and press the disc gently until it clicks into place. Close the disc door gently, otherwise, the player will not read the disc.
Note: The SE1OB is only compatible with CD, CDR, MP3 & HDCD.

Micro SD/ TF Card:
Insert the Micro SD/TF card with the arrow pointing toward the slot. and carefully slide it into the slot until it clicks into place. Turn on the player. then press and hold the  Play/Pause button until ‘Sd’ displays.
Note: The SE1OB is compatible with the MP3 format in Micro-SD Card mode only.

Repeat
Each time the MODE button is pressed, the order of the tracks played will be as follows: Repeat Current Song Only (REPI), Repeat all (ALL), Shuffle (SHUF), Preview  (INTRO) – only IO second per track will be played in this mode.

A-8 Repeat
This function allows you to select a specific audio section to repeat. This is particularly useful when learning languages or instruments.
When a CD is playing, press the button at the beginning of the section you wish to repeat. Press again at the end of the section.
The CD player will repeat the selected section.
To resume normal CD play, press once more.

Program
Press the PROG button to enter the programming mode when the play stops. press the PREVIOUS or NEXT button to select the track you want to program, press PROG  again to confirm the programming.
Up to 30 tracks can be programmed in this mode. After that, press the PLAY button to enter the programming play mode. Press the STOP button directly to enter the stop mode to cancel or reprogram.

Volume
The volume dial is located on the side of the SE I OB. Rotate it to the left or right to decrease or increase the volume. Please listen to music at an appropriate volume to avoid damaging your hearing. 

Equalizer
Press the EQ button to cycle through various sound modes. There are a total of 5 modes: Bass, Pop, Jazz, Rock & Classic.

Hold
After playback mode and EQ have been set up, you can toggle the Hold switch to On to prevent any settings from being changed.

Last Memory
ON: The player will play the most recently played track on the CD.
OFF: The player will not play the most recently played on the CD. Press and hold the PROG button to tum this function on or off. ON or OFF will be displayed on the screen.  This function is turned on by default. 

Troubleshooting

Problem: Cannot read the disc.

facing upwards.
2. Ensure the disc is fully in place.
CD is dirty or damaged.| 1. Make sure the disc is not scratched or damaged.
2. Wipe the disc gently from the center to the edge with a clean, soft cloth.
3. Try another disc to check if the disc is faulty.
The disc reader is dirty.| Wipe the lens gently with a cotton swab.

Problem: Cannot charge the battery.

turned on.
The plug is not
plugged in correctly.| Make sure that the plugs of the power cord are
connected properly.
The charger is damaged.| Please try another USB charging cable.
SE1OB is damaged.| Please contact Customer Service.

Problem: The player cannot be turned on.

Specification

Warranty

This product is guaranteed for 12 months from the date of the original purchase. In the unlikely event of any defect arising due to faulty materials or workmanship. the unit will be either replaced or repaired free of charge (where possible) during this period. An alternative product will be offered in case the product is no longer available or repairable.

This warranty is subject to the following conditions:

• The warranty is only valid within the country where the product is purchased.

• The product must be correctly installed and operated in accordance to the instructions given in this user manual.

• The product must be used solely for domestic purposes.
  The warranty only covers the main unit and does not cover the accessories.
  The warranty does not cover the damage caused by misuse, negligence, accident, and natural disaster.
  The warranty will be rendered invalid if the product is resold or has been damaged by inexpert repairs. The manufacturers disclaim any liability for incidental or consequential damages.

• Please consult our customer adviser before returning any product: we are not responsible for any unexpected product returns.

• Any faulty product must be kept and returned in the original packaging with all the accessories and the original copy of the purchase receipt.

The warranty is in addition to and does not diminish, your statutory or legal rights.
Customer Service:
Telephone: +44 (0) 845 250 0586
Email: service@augustint.com

This product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The Declaration of conformity may be consulted online  at http://www.augustint.com/en/declaration

Industry Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (I) this device may not cause interference, and  (2) this device must accept interference, including interference that may cause undesired operation of the device.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part I5 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the  user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

No Unauthorized Modifications: Do not make any changes or modifications to this product without the prior express written approval of August International Ltd. Any changes or modifications made without express written approval could void the user’s authority to operate this product.

 For details of further relevant technical standards, please contact us at the address above.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>