TRIPP LITE SRSEHOOD SmartRack Service Entry Hood Instruction Manual
- June 5, 2024
- Tripp Lite
Table of Contents
TRIPP LITE SRSEHOOD SmartRack Service Entry Hood
Installation Instructions
WARNING: Do not attempt to use the roof panel for weight-bearing purposes other than those explicitly described and approved by Tripp Lite. Do not attempt to add or remove the roof panel without assistance.
Remove the Roof Panel
Models with a Toolless Roof
- Pull the 2 pins near the rear of the roof panel A. While holding the pins, push the roof panel upward B.
- Remove the roof panel tabs A from the roof panel attachment slots B in the enclosure frame.
- Lift the roof panel from the enclosure.
Models with Screws Securing the Roof
- Models with Screws Securing the Roof attach the roof panel to the unit.
- Lift the roof panel from the enclosure.
Installing the Drip-Resistant Cable Access Housing
- Remove one of the rubber sealing plugs from the top rear of the enclosure by pushing it out from inside of the unit.
- Using the included M4 x 8 mm pan head machine screws and toothed washers (4 of each), fasten the screws into each of the threaded holes.
Tripp Lite has a policy of continuous improvement. Product specifications are subject to change without notice. Photos and illustrations may differ slightly from actual products.
WARRANTY REGISTRATION
Register your product today and be automatically entered to win an ISOBAR®
surge protector in our monthly drawing!
tripplite.com/warranty
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>