inventor DP1590S Double Door Refrigerator User Manual
- June 5, 2024
- inventor
Table of Contents
DP1590S Double Door Refrigerator
User Manual
SAFETY WARNINGS
-
WARNING ―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
-
WARNING ―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
-
WARNING ―Do not damage the refrigerant circuit.
-
WARNING ―Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
-
The appliance has to be unplugged after use and before carrying out user maintenance on the appliance.
-
This appliance can be used by children aged 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
-
Please abandon the refrigerator according to local regulators for it uses flammable blowing gas and refrigerant.
-
Please according to local regulations regarding disposal of the appliance for its flammable refrigerant and blowing gas. Before you scrap the appliance, please take off the doors to prevent children trapped.
-
This appliance is intended to be used in household and similar applications such as – staff kitchen areas in shops, offices, and other working environments;
– farmhouses and by clients in hotels, motels, and other residential type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications. -
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED SERVICE PERSONNEL TO CARRY
OUT SERVICING OR REPAIRS THAT INVOLVE THE REMOVAL OF COVERS.
TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS YOURSELF.
INSTALLATION
Location
When selecting a position for your unit you should make sure the floor is flat
and firm, and the room is well ventilated. Avoid locating your unit near a
heat source, e.g. cooker, boiler, or radiator. Also, avoid direct sunlight as
it may increase electrical consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly. This unit is not designed for use
in a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 10 cm of free space is left on both
sides, 10 cm at the rear, and 30 cm at the top of the unit. This will allow
cold air to circulate around the wine cooler and improve the efficiency of the
cooling process.
Reversing the Door Swing
Tools Required: Phillips style screwdriver / Flat blade screwdriver / Hexagonal spanner
-
Remove the right top hinger cover.
-
Remove the screws fixing the top hinge with a cross-slot screwdriver.
-
Replace the top hinge and the top-door limit block and the door bearing bush with the other side.
A. Remove the nut with the sleeve. Take off the washer then remove the axes to the other side and fixed.
B. Remove the door
limit block
C. Please take out
another door limit block, with screw mounting to the door
-
Disassemble the screws fixed the bottom hinge with a cross-slot screwdriver.
Note： the
refrigerator-freezer incline angle is less than 45°. -
Replace the bottom door-bearing bush and the limit block.
-
Replace the bottom hinge to the other side then fix it with screws.
-
Replace the mid-hinge.
-
Set the bottom door right position, and fix the mid-hinge.
-
Replace the top hinge.
-
Set the top door right position, and fix the top hinge and the cover.
-
Install the four screw caps and two catches to corresponding positions.
·Ensure the Appliance is unplugged and empty.
·Adjust the two leveling feet to their highest position.
·We recommend you have someone to assist you. -
replace the leveler to the other side and adjust it to make sure the cabinet is level.
Door Space Requirements
The unit’s door must be able to open fully as shown. W X D.;-‘902 X 1052mm
Leveling the Unit
To do this adjust the two leveling feet at the front of the unit. If the unit
is not level, the door and magnetic seal alignments will not be covered
properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise loosening, and
tightening.
Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using a ‘wrung-out’ sponge or cloth. Wash the shelves and salad bin in warm soapy water and dry completely before replacing them in the unit. Clean the exterior of the unit with a damp cloth. If you require more information refer to the Cleaning section.
Before Using Your Unit
Do not damage the power cord under any condition so as to ensure safety use,
do not use it when the power cord is damaged or the plug is worn. Do not put
flammable, explosive, volatile, and highly corrosive items in the refrigerator
to prevent damage to the product or fire accidents.
Do not place flammable items near the refrigerator to avoid fires.
This product is a household refrigerator and shall be only suitable for the
storage of foods.
According to national standards, household refrigerators shall not be used for
other purposes, such as storage of blood, drugs, or biological products.
Do not place items such as bottled or sealed containers of fluid such as
bottled beers and beverages in the freezer to prevent bursts and other losses.
Before placing any food in your unit, turn it on and wait for 24 hours, to
make sure it is working properly and to allow it time to fall to the correct
temperature. Your unit should not be overfilled.
-
Before Plugging in
You must check that you have a socket that is compatible with the plug supplied with the unit. -
Before Turning On!
Do not turn it on until two hours after moving the unit.
Interior Accessories
Various glass or plastic storage shelves are included with your appliance –
different models have different combinations.
You should always slide one of the full-size glass storage shelves into the
lowest set of guides, above the fruit and vegetable containers, and keep it in
this position. To do this, pull the storage shelf forward until it can be
swiveled upwards or downwards and removed.
Please do the same in reverse to insert the shelf at a different height.
In order to make the most of the volume of the fresh food storage compartment
and frozen-food storage compartment, the user can remove one or more shelves,
and drawers, out of the appliance, according to your daily use.
PRODUCT OVERVIEW
*All images in this instruction manual are for indication only; please refer to your individual unit for details.
OPERATION
Switching On Your Unit
-
The temperature selector knob is located on the right-hand side wall of the refrigerator interior
Setting “Off”: UnitOff
Setting “Min”: Less Cool Temperature
Setting “Med”: Normal Operation(adequate for most situations)
Setting “Max”: Coolest Temperature -
During high ambient temperatures e.g. on hot summer days. It may be necessary to set the thermostat to the Coolest setting(position“Max”). This may cause the compressor to run continuously in order to maintain a low temperature in the cabinet.
-
For the first time, you install your refrigerator, and set the thermostat knob at “Med”.
Give your refrigerator time to cool down completely before adding food. It is best to wait 24 hours before adding food. The thermostat knob controls the temperature. When the thermostat control knob is set to OFF, the refrigerator will not be running.
Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are
perfectly normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the
cooling system. It has become more pronounced since the introduction of CFC-
free gases. This is not a fault and will not affect the performance of your
unit. This is the compressor motor working, as it pumps the refrigerant around
the system.
Tips for Keeping Food in the Unit
- Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid a bacterial transfer. Keep raw meats/fish in a container that is large enough to collect juices and cover them properly. Place the container on the lowest shelf.
- Leave space around your food, to allow air to circulate inside the unit. Ensure all parts of the unit are kept cool.
- To prevent the transfer of favors and drying out, pack or cover the food separately. Fruit and vegetables do not need to be wrapped.
- Always let pre-cooked food cool down before you put it in the unit. This will help to maintain the internal temperature of the unit.
- To prevent cold air from escaping from the unit, try to limit the number of times you open the door. We recommend that you only open the door when you need to put food in or take food out.
Change the Light Bulb
Lamp replacement by professionals
CLEANING
Cleaning the Interior and the Exterior of the Unit
- Remove all the shelves and the salad bin. To remove the salad bin first remove the lower door shelf.
- Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with warm water using a“wrung-out” sponge or cloth. Wipe completely dry before replacing the shelves and salad bin.
- Use a damp cloth to clean the exterior, and then wipe with standard furniture polish. Make sure that the door is closed to avoid the polish getting on the magnetic door seal or inside the unit.
- The grille of the condenser at the back of the unit and the adjacent components can be vacuumed using a soft brush attachment.
Cleaning Tips
Condensation may appear on the outside of the unit. This may be due to a change in room temperature. Wipe off any moisture residue. If the problem continues, please contact a qualified technician for assistance.
MAINTENANCE
-
Changing the Internal Light
Lamp replacement by professionals. -
Care When Handling / Moving Your Unit
Hold the unit around its sides or base when moving it. Under no circumstances should it be lifted by holding the edges of the top surface. -
Servicing
The unit should be serviced by an authorized engineer and only genuine spare parts should be used. Under no circumstances should you attempt to repair the unit yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunction. Contact a qualitative technician. -
Switching Of for Long Periods of Time
When the unit is not in use for a long period of time, disconnect it from the main supply, empty all food, and clean the appliance, leaving the door ajar to prevent unpleasant smells.
Troubleshooting
The following simple issues can be handled by the user. Please call the after- sale service department if the issues are not settled.
In operation| Whether the freezer is plugged and connected to power; Low
voltage;
Failure of power or tripping circuit
---|---
Odor| Odorous foods should be closely wrapped; Whether foods are rotten;
Whether the interior shall be cleaned.
Long-term operation of the compressor| it is normal that the refrigerator
operates for a longer time in summer when the ambient temperature is higher;
Do not put too much food In the freezer at one time; Do not put foods until
they are cooled;
Frequent opening of the refrigerator door.
Illuminating light does not shine| Whether the refrigerator is connected to
power, whether the Illuminating light is damaged.
The refrigerator door can not be properly closed.| The freezer door is stuck
by food packages;
Too much food;
Tilt refrigerator.
Loud noises| Whether the food is leveled, whether the refrigerator is
balanced;
Whether the refrigerator parts are properly placed.
Warm tips:
- The refrigerator enclosure may emit heat during operation, especially in summer, this is caused by the radiation of the condenser, and it is a normal phenomenon.
- Condensation: condensation phenomenon will be detected on the exterior surface and door seals of the freezer when the ambient humidity is large, this is a normal phenomenon, and the condensation can be wiped away with a dry towel.
- Buzz: Buzz will be generated by running a compressor, especially when starting up or shutting down.
TIPS FOR ENERGY SAVING
Try not to open the door too often, especially when the weather is wet and
hot. Once you open the door, close it as soon as possible.
Every now and then check if the appliance is sufficiently ventilated (adequate
air circulation behind the appliance).
In normal temperature conditions, please arrange the thermostat in the middle
setting.
Before loading the appliance with packages of fresh food, make sure they are
cooled to ambient temperature.
Ice and frost layers increase energy consumption, so clean the appliance as
soon as the layer is 3-5 mm thick.
If it is the outer condenser, the rear wall should be always clean and free of
dust or any impurities.
-
The appliance should be located in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.
-
Let hot foods cool to room temperature before placing them in the appliance. Overloading the appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality or spoil.
-
Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance.
This cuts down on frost build-up inside the appliance. -
The appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the appliance less efficient. -
Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time, and close the door as soon as possible.
DISPOSAL
Old units still have some residual value. An environmentally friendly method
of disposal will ensure that valuable raw materials can be recovered and used
again. The refrigerant used in your unit and insulation materials requires
special disposal procedures. Ensure that none of the pipes on the back of the
unit are damaged prior to disposal. Up to date information concerning options
of disposing of your old unit and packaging from the new one can be obtained
from your local council office.
When disposing of an old unit break off any old locks or latches and remove
the door as a safeguard.
Correct Disposal of this product
| Correct Disposal of this product
This marking indicates that this product should not be disposed of with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmentally safe recycling.
For more information, please contact the local authority or your retailer where you purchased the product.
Activate your Warranty
- Visit our website and activate your warranty via the below link or by scanning the QR code
https://www.inventorairconditioner.com/warranty-inventor
https://www.inventorairconditioner.com/warranty-inventor
- Fill all the fields as shown below
Once the warranty submission
has been completed a confirmation message will be sent to your email
REFRIGERATOR
DOUBLE DOOR
https://www.inventoraircondition.gr/media-library
Scan here to download the latest version of this manual.