nedis WLPSRL101BK Wireless Laser Presenter Instruction Manual

: June 5, 2024
: nedis

Table of Contents

Description
General safety
Battery safety
Support
FCC Warning
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WLPSRL101BK
Wireless laser presenter

Description

1. On/off button|

Use the button to turn on or off the device.

---|---
2. Volume button|

Use to button to increase or decrease the volume of the presentation.

3. Play button|

Use the button to start the presentation.

4. Page up button
5. Page down button|

Press the buttons to navigate through the pages of the presentation.
To switch between different pirating systems, simultaneously press and hold the buttons for 3 seconds.

6. Escape button|

Use the button to stop the presentation.

7. Black screen/exit button|

Press the button to enter or exit a black screen.

8. Laser button
9. Laser pointer|

Press the button to use the laser pointer. Use the red laser light to point to the screen.

10. LED indicator|

Light is on for 3 seconds: The device is on.
Light flashes slowly: The battery is low.
Light flashes quickly: The device is in pairing mode.

11. Battery compartment|

To pair the device with the computer, put the batteries in the battery compartment. Turn on the device. Simultaneously press the page up button and the page down button.
Use AM batteries (2x).

Safety

General safety

Read the manual carefully before use. Keep the manual for future reference.
The manufacturer is not liable for consequential damages or for damages to property or persons caused by non-observance of the safety instructions and improper use of the device.
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
The device is suitable for indoor use only. Do not use the device outdoors.
The device is suitable for domestic use only. Do not use the device for commercial purposes.
Do not use the device in locations with high humidity, such as bathrooms and swimming pools.
Do not use the device near bathtubs, showers, basins, or other vessels containing water.
Do not use a timer or a separate remote-control system that switches on the device automatically.
Do not cover the device.
Keep the device away from flammable objects.

Battery safety

Use only the batteries mentioned in the manual.
Do not use old and new batteries together.
Do not use batteries of different types or brands.
Do not install batteries in reverse polarity.
Do not short-circuit or disassemble the batteries.
Do not expose the batteries to water.
Do not expose the batteries to fire or excessive heat.
Batteries are prone to leakage when fully discharged. To avoid damage to the product, remove the batteries when leaving the product unattended for longer periods of time.
If the liquid from the batteries comes into contact with skin or clothing, immediately rinse with fresh water.

Support

If you need further help or have comments or suggestions, please visit www.nedis.com/support

FCC Warning

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
FCC ID: 2A4NB-P5000

WLPSRL101BK_MAN_COM_0319.indd 2
7-3-2019 14:26:53