D-Link DWA-F18 VR Air Bridge User Guide

: June 5, 2024
: D-Link

Table of Contents

Contents in the box
Best placement for VR Air Bridge
Set-up
Support
FCC INTERFERENCE STATEMENT
CANADA ISED NOTICE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

D-Link DWA-F18 VR Air Bridge User Guide

Contents in the box

Best placement for VR Air Bridge

Use these tips to get the best performance

In the same room as the VR headset
Line of sight (unobstructed view between VR Air Bridge and VR headset)
Desk height
Keep the VR Air Bridge vertical using the companion stand.

Set-up

Go to oculus.com/setup to download and / install the Quest Link Software. For those who have the software already, ensure you are running the most recent version, if not, update and reboot your computer.
Connect the VR Air Bridge to a USB 3 / port on your computer (they are blue).

Emoji Open the Quest Link Software and check that VR Air Bridge is detected.

Support

For more information about PC compatibility requirements with Quest headsets, please visit support.oculus.com

For additional support, go to: https://support.dlink.com

FCC INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio technician for help.

Federal Communication Commission (FCC)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body.
For Portable Device Usage

Radiation Exposure Statement:

The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)

Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.

Changes or modrications not authorized by the party responsible for compliance could void the user’s authority to operate this product.

CANADA ISED NOTICE

This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Caution:

the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.

Radiation Exposure Statement:

The product comply with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved ifthe product can be kept as far as possible from the user body orset the device to lower output powerif such function is available.

The products are compliant with SAR for general population/uncontrolled exposure limits in IC RSS-102 and has been tested in accordance with the measurement methods and procedures specified in IEEE 1528. Maintain at least 5mm distance for body-worn condition.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body.