KRAFT KF-CHN10CSW Convection Heater User Guide

: June 3, 2024
: KRAFT

Table of Contents

KF-CHN10CSW Convection Heater
SAFETY INFORMATION
DEVICE DESCRIPTION
ASSEMBLY INSTRUCTIONS
USAGE
CLEANING AND STORAGE
SPECIFICATION / CONFIGURATION
WARRANTY CARD
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CONVECTION HEATER

KF-CHN10CSW Convection Heater

KRAFT KF CHN10CSW Convection Heater-

KF-CHN10CSW
USER GUIDE

DEAR BUYER!
Congratulations on the purchase of your KRAFT convection heater.
Please read these instructions carefully before using the heater, which contains important information regarding your safety as well as recommendations for the proper use and care of the heater. If you encounter any problems while using the heater, please contact us.
Thank you for your purchase!
Do not expose the device to sudden changes in temperature. Sudden changes (e.g. moving from freezing temperatures to warm temperatures) may cause conde station in the interior of the heat exchanger. condensation inside the unit and may prevent the unit from working properly when switched on. When the heater is switched on. After storage at low temperatures or after transportation in winter conditions, the heater may not be switched on until at least 6 hours at room temperature when unpacked.

SAFETY INFORMATION

For your safety and proper use of your convection heater, please read these instructions carefully before use, and retain it for re-reading after shipping or selling the unit. Improper handling of the appliance may result in damage to the appliance, damage to property, or injury to the user.

The device is intended exclusively for use in the home. Do not use the device outdoors.
Only use the device in accordance with the instructions. Any use of the device for purposes other than those intended by the manufacturer is prohibited.
When removing the device from its packaging, make sure it is intact and undamaged. Keep the packaging materials away from children. Dispose of the packaging correctly.
This appliance is not intended for use by persons with reduced physical This the appliance is not intended for use by persons (including children under 8 years of
age) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they are supervised or instructed by a person responsible for their
safety. Children should not play with the parts of the appliance. Use, maintenance, and cleaning shall not be made by children without supervision.
The equipment must be connected to the mains in full compliance with the rules and regulations in force in the country.
Before connecting the appliance to the mains, make sure that the voltage and the voltage and frequency of the power supply correspond to those indicated on the
product’s label.
Connect the appliance only to an AC power source through a socket with reliable contacts and a ground connection.
Never use a makeshift fuse or a fuse with inadequate protection for the power supply. fuses or fuses with inadequate specifications. The use of metal or copper wires as a fuse may result in malfunction or fire.
Do not connect the appliance to a timer or other device that automatically controls the on/off operation of the appliance.
Do not use an extension cord to connect the heater. If the use of an extension cord is necessary, then carefully follow the instructions provided with the cord, not exceeding the amperage limit shown on the cord.
Do not unplug the power cord while the heater is operating. turn off the heater first, using the power control knob.
To avoid overloading the power supply, do not use the heater at the same time as other high-wattage appliances.
When disconnecting the appliance from the mains, never pull the power cord or the appliance itself. Never pull the power cord or the appliance itself when unplugging it,
but grasp the plug of the power cord only.
Be sure to remove the plug from the power outlet when the heater is not in use for an extended period of time.
Never pinch, cut or extend the power cord. Damage to the power cord may result in electric shock, short circuits, or fire.
When installing the unit, make sure that the electrical outlet is easily accessible.
Do not install the unit in the immediate vicinity of a power outlet.
Do not place the unit within 100 cm of furniture, walls, curtains, or other objects.
Do not obstruct heater ventilation holes. Do not lean against it, and do not hang or stack objects on top of the heater. Doing so may cause the heater to overheat and cause a fire.
Doing so may cause the heater to overheat and cause a fire. If the ventilation holes are clogged, clean them with a soft, damp cloth and a vacuum cleaner.
Never insert foreign objects into the openings Never push objects of any kind into the openings on the cabinet. Doing so may result in injury, electric shock, or damage to the product.
Doing so may result in personal injury, electric shock, or damage to the unit.
Do not touch the heater while it is in operation to avoid burns. If you must move the heater, grasp the handles, use an oven glove, or Allow it to cool down first.
Do not leave the heater unattended while it is in operation. Before leaving Turn the Mode Switch to the off position and disconnect the unplug the power cord from the electrical outlet.
If you need to use the appliance while you sleep, make sure there are no objects such as textiles near the appliance,
Do not place or use this appliance near textiles, sheets, etc. in order to avoid causing accidents.
Do not place or use the device near flammable mixtures, sprays, or explosive or flammable gases. There is a danger of ignition.
Do not use the unit near an open flame, stove, or any other heating device.
The appliance is not designed for use in an environment of high humidity and condensation
Do not use the heater in the vicinity of a bathtub, shower, or swimming pool so that it will not fall into the water.
Do not touch the unit with wet hands.
The manufacturer is not responsible for the consequences of improper use of the appliance or failure to observe safety precautions or precautions, or resulting from improper installation.
Maintenance work on the equipment must only be carried out by qualified technical personnel. Otherwise, the User is responsible for safety and compliance with the installation, care, and maintenance regulations.
Only spare parts recommended by the manufacturer may be used for repairs.
Although these instructions try to cover the greatest number of circumstances that arise when using the appliance, care and common sense are required in any case, as with common sense and common sense as with any electrical appliance, especially when children are present.

DEVICE DESCRIPTION

KRAFT KF CHN10CSW Convection Heater-fig1

The device shown in the image is for guidance only and can be selected from your model.

ASSEMBLY INSTRUCTIONS

HOW TO INSTALL THE FEET

KRAFT KF CHN10CSW Convection Heater-fig2

Please assemble the feet and the body in the order given in the picture below:

Place the convector on the flat desk or carton.
Insert the 4 position fins of the feet into the position holes of the body.
Tight the fixed screw to connect the body .and feet.
In the same way, attach the second pair of casters to the other side of the heater

USAGE

Please check before you use:
A: The heating wire and electric wire can not be broken.
B: Please do not use the socket lower than 10A for fear of any accident.
Use the convector in a flat place to avoid being toppled.
There are 2 switches for the power setting. “I” is for 800W, and “II” is for 1200W. You can get 3 power settings 800W, 1200W, and 2000W(800W+1200W).
There is a thermostat knob for adjusting heating. You can rotate the knob to get your desired heating level.
For the convector with turbo, there is an independent switch for this function.
If you stop using the convector, turn off all the power switches, then put off the plug.
If you want to move the convector, please turn off the switches, then put off the plug, and hand on the handle on the back of the convector.

CLEANING AND STORAGE

An heater requires regular maintenance. At least
At least once every 10 days you should clean the appliance.
Before cleaning, turn the mode switch to the 0 (OFF) position, unplug the power cord and allow the unit to cool completely.
Use a damp cloth for cleaning. Before each subsequent use, make sure the heater is fully assembled and working properly.
Do not touch the hot surfaces of the heater. If you need to move the heater, grasp the handle or use an oven glove.
Wipe the outside of the heater with a soft, damp cloth.

ATTENTION! Do not allow water or other liquids to come in contact with the controls. controls or the interior of the appliance as this may result in electric shock and/or fire. electric shock and/or fire. Do not use solvents or abrasive agents for cleaning as they may damage the Do not use solvents or abrasive agents for cleaning. Store the instrument in a clean and dry place when not in use.

DISPOSAL
Before disposal, the washing machine should be completely unusable for safety reasons. Remove the plug of the power cable from the wall outlet, cut the power cable as close to the wall of the device as possible, and remove the door so that children do not lock themselves or get an electric shock while playing. The appliance cannot be disposed of together with ordinary household waste. To prevent possible health and environmental hazards, the device must be disposed of as part of an approved disposal process. In the future, you should act in accordance with local regulations regarding the disposal of waste and garbage.

SPECIFICATION / CONFIGURATION

Model	KF-CHN10CSW
Power, W)	2000
Power Range(W)	800 / 1200 / 2000
Voltage (V) / Frequency (Hz)	220 / 50
Heating room area (m2)	15-20
Rated current (A)	9.1
Weatherproof design	IPX0
Protection class from electric shock	I
Color	white/black

The manufacturer reserves the right to change the designs, specifications, appearance, and configuration of the product without impairing its consumer qualities, without prior notice to the customer.
All information provided in the manual concerning the configuration, technical characteristics, functions, and colors is purely informational in nature and under no circumstance is a public offer.

Manufacturer:
NINGBO CHANGER ELECTRON CO., LTD.
Address: 373, Xinxin Road, Cixi City,
Ningbo, Zhejiang prov., China
Importer:
ООО SARMAT.
Address: No 50 V, Dnepropetrovskaya
Str. Apt. 2, Rostov-on-Don, Russia, PC
344093
Tel.: +7 800 200 79 97
Made in China

WARRANTY CARD

Date of sale

Store stamp
When selling, the seller is obligated to fill out the warranty coupons. The date of manufacturing and serial number can be found on the packaging and on the back side of the product.

The manufacturer’s warranty obligations are valid only for the KRAFT convection heater. The warranty period is 1 year from the date of purchase. The service life of the product conducted 3 years.
Information about authorized service centers is available on the website http://kraftltd.com or by calling the support service toll-free at +7(800)200-79-97. If you have any questions or problems related to KRAFT products, please contact us in writing at the address: ZAO “LEBEDINSKY TORGOVIY DOM”, str. Dnepropetrovskaya, 50 V, Rostov-on-Don, 344093, Russia, or by e-mail service@lbtd.ru.

The manufacturer guarantees the free elimination of factory defects or technical faults during the warranty period if the Buyer complies with the terms and conditions of warranty service. All claims in appearance should be presented to the seller when purchasing the product. After purchasing the product, the consumer is responsible for all external damage.
The warranty applies only to products used for non-commercial personal, family or household
purposes. Otherwise, the warranty period is 3 months from the date of purchase.
The seller reserves the right to conduct a technical examination of the product quality within the time frame established by law.
Warranty repairs are not performed in the following cases:
– invalidity of the warranty card;
– the presence of damage and malfunctions resulting from improper use of equipment in violation of the rules of operation, installation or transportation of equipment by the user or a trading organization;
– the presence of damage and malfunctions resulting from the action of third parties or force majeure, ingress of foreign objects and insects, damage caused by animals;
– establishment of the fact of deviation from the State technical standards, supplying electrical and cable networks, supplying more power than provided by the manufacturer;
– establishment of the fact of repair (attempt to repair) equipment independently or by unauthorized persons;
– using the product for industrial or commercial purposes.
The warranty card is invalid in the following cases:
– incorrect or incomplete filling of the card by the store and the master;
– absence of the sale date and the store stamp.
The manufacturer is not responsible for damage caused to people, animals, and premises due to violation of safety regulations, transportation, and operation of the device.
The warranty service does not cover installation, cleaning and maintenance of the device.