nedis INKI112CBK4 Insect Killer with 4/6 Watt LED User Guide

Insect Killer
With 4 or 6 Watt LED
INKI112CBK4 | INKI112CBK6

http://ned.is/INKI112CBK6  http://ned.is/INKI112CBK4

ned.is/inki112cbk4 ned.is/inki112cbk6
Quick start guide

Specifications

Quick start guide

Insect Killer

For more information see the extended manual online: ned.is/inki112cbk4 | ned.is/inki112cbk6

Intended use

The Nedis INKI112CBK4 | INKI112CBK6 is an electronic insect killer.
It utilizes a UV-A LED tube to attract light-sensitive flying insects, such as flies, moths, and mosquitoes.
These insects are electrocuted by the electrically charged inner metal grid.
The product is intended for indoor, and domestic use only.
This product can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the product in a safe way and understand the hazards involved.
Any modification of the product may have consequences for safety, warranty, and proper functioning.

Main parts (image A)

1. Chain ring
2. Housing
3. Metal grid
4. UV-A LED lamp
5. Power cable
6. Tray

Safety instructions

  WARNING

• Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
• Only use the product as described in this document.
• The manufacturer is not liable for consequential damages or for damages to property or persons caused by non-observance of the safety instructions and improper use of the product.
• Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
• Do not use the product for outdoor uses, the product is designed for indoor use.
• The product is intended for domestic use only.
• Do not use this product in a bathtub, shower, or water-filled reservoir.
• Do not immerse the product, the power cable, or plug in water or other liquids.
• After the product has been immersed or covered in water or other liquids, do not use the product again.
• Keep the product away from heat sources. Do not place the product on hot surfaces or near open flames.
• Keep away from flammable gases, vapor, or explosive dust.
• Keep distance from flammable objects.
• Do not open the product.
• High voltage! Do not touch the inner metal grid.
• Do not look directly into the light, this may cause eye damage.
• Never put metal objects inside the grid.
• Keep your hands away from the grid. Do not insert fingers, pencils, or other objects through the guard.
• Do not use the product in barns, stables, and similar locations.
• Do not expose the product to water or moisture.
• Always disconnect the product from the power outlet before cleaning or moving the product.
• Do not drop the product and avoid bumping.
• Do not use the product for more than 8 hours a day, due to the radiation.
• Keep the product out of reach from children.
• Cleaning and user maintenance shall not be done by children without supervision.
• Children shall not play with the product.
• For replacement, use lamps of the same type and rating only.
• This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
• Disconnect the product from the power outlet and other equipment if problems occur.
• Do not use the product when the cable or plug is damaged.
• Always unwind the power cable before using the product.
• Do not pull the power cable to move the product.
• Do not let the power cable hang over the edge of a table or counter.
• Do not leave the product unattended when the product is connected to the power outlet.
• Before cleaning and maintenance, switch off the product and disconnect the power. Let the product cool down completely.
• Do not cover the product when in use.
• Do not use the product in barns, stables, and similar locations.
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the product.
• Do not attempt to repair the product. If the product does not operate correctly, replace it with a new product.
• Never put metal objects inside the grid.

Installing the product (image A)

1. Hang the product with the chainring A1 to the ceiling.
2. Connect the power cable A5 to a power outlet.

Maintenance

 Always disconnect the product from the power outlet before cleaning or moving the product.
Do not use cleaning solvents or abrasives.
Do not attempt to repair the product. If the product does not operate correctly, replace it with a new product.
Clean the outside of the product with a soft, clean, slightly damp cloth.
Empty the tray A6 at least once a week.
The LED lamp A4 cannot be replaced.

References

• Smart solutions for your daily needs | Nedis
• Smart solutions for your daily needs | Nedis

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>