indiamart WD2036B LED Tail Lights User Manual
- June 16, 2024
- indiamart
Table of Contents
LED Tail Lights
WD-2036B user manual
WD2036B LED Tail Lights
Function switch mode: Turn on the running light and double flash button to switch the following modes. Red cursor2. Yellow cursor3. Red water4. Yellow water 5. Red light with-out water 6. Yellow light no running water Turn on the running light and press for more than 5 seconds to flash the light to enter whether the driving dynam-ic selection
- Plug – Open double flash according to the original car function, red double flash
- Unplug – the connector is connected to the high brake light and the double flashing and separate steering function are consistent
BT mode:
Scan and Download RGB version http://download.appglobalmarket.com/happylightingdownload.html
- You can download the RGB controller from the app store, or scan the QR code below to download it.
- Open the app, select Bluetooth device, select Scan, and the device WD-2036B will be displayed. Click Connect. If the connection is successful, the car lights will flash quickly and then turn off. If the connection is not successful, please power on the car lights again.
- After successful connection, the color of the light can be adjusted as needed.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>