SUNSKY S3 Low-Power Smart Camera User Manual
- June 5, 2024
- sunsky
Table of Contents
SUNSKY S3 Low-Power Smart Camera User Manual
I.Appearance Introduction
RESET: Turn the switch button to “On”, press and hold the
RESET button for about 5s until the red and blue lights are all on, then the
blue light flashes slowly, and hear a beep, reset is successful.
II．App Download
Direct scanning of QR Code to download“Botslab”APP;
Android phone can search“Botslab”on Google Play or other application markets
to download APP;
iPhone/iPad can downloaded“Botslab”on App Store.
III．Registered User
Open the APP and click “Sign up”, enter your phone number or email to
register, receive the verification code, and set the password to complete the
registration.
Note: When logging in to your account, the location should select your current
area. E.G:
IV．AP Mode Connection Settings
Preparation: Toggle OFF/ON switch to turn on camera;
V．WiFi Remote Monitoring Settings
Note: The phone needs to connect a 2.4G WiFi.
VI．AP Mode And P2P Mode Device List Distinction
-
When logging in, correctly select the area where the device is currently located, otherwise the device cannot be added or the device is offline.
-
The device only supports 2.4G network (please don’t select 5G network when configuring the network).
-
If the device AP hotspot can be searched, but cannot be connected during network configuration, please delete or forget the hotspot in the WLAN settings, then reconfigure the network again. E.G:
-
Click “Settings”-“Memory Card Settings”-“Recored Mode”-“Continuous Recording” , the device will stop sleeping and continue recording.E.G:
-
The device is bound by other users: the device can only be bound by one ID, other users cannot continue to bind, and can only be used after the original account is unbound.
-
Device sharing: The device can be shared to multiple users, and permissions can be set for different users, and they can be watched online at the same time.
-
Cloud storage tariffs are subject to the APP. Different regions and different discounts may have different （3）Check and click Next tariffs.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any inte rference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interferenceto radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>