VonHaus 2000067 4 In 1 Hand Blender Instruction Manual

VonHaus 2000067 4 In 1 Hand Blender

INTENDED USE.

Only operate the VonShef® 4 in 1 Hand Blender for its intended purpose and within the parameters specified in this manual.
This appliance is not suitable for commercial or industrial use.
This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless supervised or given appropriate instruction concerning the product’s use by a person responsible for their safety.
This Hand Blender is not intended for use by children.

GENERAL PRECAUTIONS.

When using an electrical appliance, basic precautions should always be followed, including the following:
Do not allow it to be used as a toy. Children should be supervised to ensure they do not play with the Hand Blender.
If the Hand Blender is not functioning properly, has been dropped, damaged, left outdoors, or immersed in liquid, do not use, contact DOMU Brands Customer Services.
Do not use the Hand Blender if any parts appear to be faulty, missing, or damaged.
Ensure all parts are securely attached before use.

CABLES AND PLUGS

Do not handle the plug or appliance with wet hands.
Check to ensure your electricity supply matches that shown on the rating plate. The product should only be used as rated. Preferably, the socket-outlet should be protected by a Residual Current Device (RCD).

The use of an extension cable is not recommended.

Do not use a damaged cable or plug. If the supply cable is damaged, it must be replaced by a qualified engineer in order to avoid a hazard.
Do not pull the cable around sharp edges or corners.
Keep the cord away from heated surfaces.
Do not let the cord hang over the edge of the table or countertop where it could be pulled on inadvertently by children or pets.
Do not leave it unattended when plugged in. Unplug from outlet when not in use.
Turn off all controls before unplugging.
Do not unplug by pulling on the cable. To unplug, grasp the plug, not the cable.
Always unplug before performing user maintenance, connecting or disconnecting attachments or changing accessories.
Ensure the cable is stored safely to prevent hazards.

SAFETY INSTRUCTIONS

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE.

RISK OF PERSONAL INJURY.
Always locate your appliance away from the edge of the worktop, on a firm, flat, heat-resistant surface with sufficient space around all sides.
The Hand Blender is not intended to be operated by means of an external timer or separate remote-control system.
Do not add boiling liquids or foods to the Chopper Bowl. Always allow time for ingredients to cool before blending.
Do not use the Hand Blender to crush ice.
Always operate the Chopper Bowl with the Chopper Coupling Unit securely in place. The Chopper Bowl may leak if it is overfilled, or if the Chopper Coupling Unit is damaged or incorrectly fitted.
When used for the first time, your Hand Blender may give off a ‘new’ smell or vapor. This will dissipate after a few uses.
Do not insert any objects into openings or cover the appliance.
Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts.

THERMAL CUT-OUT.
The 4 in 1 Hand Blender is equipped with a safety thermal cut-out switch. Should the appliance overheat, the thermal cut-out switch will activate and shut down the appliance. Unplug and allow to cool for 30 minutes before using again.

TECHNICAL SPECIFICATION

• VOLTAGE: V: 220-240
• RATED POWER: W: 800
• RATED FREQUENCY: Hz: 50-60

PRODUCT SPECIFICATION

1. START/STOP BUTTON (I).
2. TURBO BUTTON (II).
3. VARIABLE SPEED CONTROL.
4. MOTOR UNIT.
5. BLENDER STICK.
6. WHISK
7. WHISK COUPLING UNIT.
8. CHOPPER COUPLING UNIT.
9. CHOPPER BLADE.
10. SLIP-RESISTANT CHOPPER BOWL.
11. BEAKER.

BEFORE FIRST USE

Before using this appliance for the first time, please ensure you complete the following steps:

• Remove all packaging and labels.
• Inspect the product for any damage and check that all parts are included.
• Before initial use, wash all accessories that come into contact with food using warm soapy water.
• Wipe down the MOTOR UNIT using a clean damp cloth.
• Prepare any large ingredients by cutting them into 2cm pieces ready for processing.
  IMPORTANT: Any hot ingredients being used must be left to cool down before blending. The temperature of ingredients should not exceed 60ºC.

OPERATION – BLENDER STICK

The BLENDER STICK is perfect for blending liquids, dairy products, sauces, fruit juices, soups, mixed drinks and shakes.

• Attach the BLENDER STICK to the MOTOR UNIT. Twist the BLENDER STICK clockwise to lock into position.
  IMPORTANT: The BLENDER STICK must
  be completely locked into position for the appliance to operate correctly. Ensure it is secure.

• Add your ingredients to the BEAKER or other suitable container. Do not exceed 600ml.

• Plug the assembled BLENDER STICK/MOTOR UNIT into a suitable mains socket and immerse the end of the BLENDER STICK completely into the ingredients.

• Press and hold the START/STOP BUTTON (I) to begin. If necessary, increase the speed during the blending process using the VARIABLE SPEED DIAL settings on the top of the MOTOR UNIT. Alternatively, to operate on maximum speed, press and hold the TURBO SPEED BUTTON (II).
  NOTE: The VARIABLE SPEED CONTROL function only works when the START/STOP BUTTON (I) is held down.

• Move the appliance slowly around the BEAKER or container in an up and down motion. WARNING! Keep hands well away from the blades whilst in operation. They are extremely sharp.
  CAUTION: Do not use continuously for more than 30 seconds at a time and allow a 1-minute resting period before using again.

• Once blending has finished, release the START/STOP BUTTON (I) to stop the appliance and unplug from the mains.

OPERATION – CHOPPER

Use the CHOPPER for chopping ingredients such as nuts, meat, onions, hard cheeses, boiled eggs, herbs and dry bread.

• Attach the CHOPPER COUPLING UNIT to the MOTOR UNIT.

• Twist the MOTOR UNIT clockwise to lock into position.
  IMPORTANT: The CHOPPER COUPLING UNIT must be completely locked into position for the appliance to operate correctly. Ensure it is secure.

• Fit the CHOPPER BLADE over the metal pin in the center of the CHOPPER BOWL.
  CAUTION: Take care when attaching and detaching the CHOPPER BLADE as it is very sharp.

• Add your ingredients to the CHOPPER BOWL. CAUTION: Do not overfill the CHOPPER BOWL with ingredients (MAX 500ml).

• Sit the assembled CHOPPER COUPLING UNIT and MOTOR UNIT onto the CHOPPER BOWL, ensuring it fits correctly into the opening on the CHOPPER BLADE attachment.

• Select the desired speed and carefully apply pressure to the MOTOR UNIT to ensure that the CHOPPER COUPLING UNIT stays attached to the CHOPPER BOWL. Hold down the START/STOP BUTTON (I) to begin.
  NOTE: If any ingredients become stuck to
  the sides of the CHOPPER BOWL, release
  START/STOP BUTTON (I) and add a small amount of liquid to the mixture or use a spatula to scrape the sides of the CHOPPER BOWL and then try again.
  CAUTION: Do not operate continuously for more than 30 seconds at a time. Allow resting periods of 1 minute in between to reduce the risk of overheating.

• Once the desired consistency has been achieved, release the START/STOP or TURBO BUTTON and unplug the MOTOR UNIT.

• Carefully remove the CHOPPER COUPLING UNIT from the CHOPPER BOWL and take out the CHOPPER BLADE from the center.

• Twist the CHOPPER COUPLING UNIT anticlockwise to remove it from the MOTOR UNIT.

OPERATION – WHISK

The WHISK is suitable for whipping cream, whisking egg whites, and preparing dessert mixtures.

• Attach the WHISK to the WHISK COUPLING UNIT by firmly pushing into the center.

• Connect the WHISK/COUPLING UNIT to the MAIN UNIT by twisting the COUPLING UNIT clockwise to lock into position.
  IMPORTANT: The WHISK COUPLING UNIT must be completely locked into position for the appliance to operate correctly. Ensure it is secure.

• Place your ingredients into a large, deep bowl.

• Plug in the MOTOR UNIT and immerse the WHISK completely into the ingredients. To avoid any ingredients splashing, select a steady speed with the VARIABLE SPEED DIAL. Set to low to begin with then increase during operation if required.
  IMPORTANT: Always immerse attachments into the ingredients BEFORE switching on.

• Rotate the appliance around the bowl to ensure all the ingredients are evenly mixed. CAUTION: Do not operate continuously for more than 30 seconds at a time. Allow resting periods of 1 minute in between to reduce the risk of overheating.
  Once whisking is complete, release the START/STOP BUTTON (I) and unplug.

• Disconnect the WHISK from WHISK COUPLING UNIT and detach the COUPLING UNIT from the MOTOR UNIT. Thoroughly clean attachments as described on page 7.

RECOMMENDATIONS

CAUTION: DO NOT OPERATE THE APPLIANCE FOR MORE THAN 30 SECONDS.

CLEANING & MAINTENANCE

CAUTION: Before carrying out cleaning or maintenance, disconnect the appliance from the mains.

• Clean the surface of the MOTOR UNIT with a damp cloth. A multi-purpose spray cleaner may be used.
  WARNING! Do not immerse the MOTOR UNIT in water or any other liquid.
  CAUTION: Do not use abrasives, harsh cleaning solutions or metal scourer pads as continued use will scratch the stainless steel surface and make subsequent cleaning more difficult.
  NOTE: Only the WHISK is dishwasher-safe. Do not wash any other attachments in a dishwasher. Hand-washing is recommended; leave to soak in warm soapy water and wipe using a sponge. Rinse and dry thoroughly.

• Wash the BLENDING STICK in warm soapy water and scrub using a cleaning brush.
  CAUTION: Take extra care when cleaning the BLENDING STICK as the blades are very sharp. The use of a long-handled cleaning brush is recommended.

• Ensure all attachments are completely dry before storing with the power cord loosely coiled out of reach of children.

TIP: To clean the CHOPPER BOWL, simply fill with warm soapy water and attach the CHOPPER COUPLING UNIT (ensuring the CHOPPER BLADE has been attached also). Connect the MOTOR UNIT to the top of the CHOPPER COUPLING UNIT and activate the turbo function by pressing and holding the turbo button (II) for up to 30 seconds. Disconnect from the mains and detach all components, then rinse with clean water before thoroughly drying with a soft cloth or paper towel. The same method can also be used for the BLENDING STICK and BEAKER.

TROUBLESHOOTING

PROBLEM

THE BLENDER DOES NOT TURN ON.

| SOLUTION

•       Ensure the Hand Blender is plugged in and turned on at the mains.

•       The Blender may have overheated due to excessive use. Allow the Blender to cool for several minutes before restarting.

---|---

MIXTURE NOT BLENDING.

|

•       The ingredients added may be too large. Cut into smaller pieces and try again.

•       Increase the speed setting using the VARIABLE SPEED DIAL.

•       Stop the Blender, unplug and clean around the blades.

SPLASHES OCCURS WHEN BLENDING.

|

•       Always immerse the WHISK/BLENDER STICK into the mixture BEFORE switching on.

•       Use a larger/deeper bowl, even when mixing small mixtures.

•       Begin operating using a steady (low) speed and gradually increase as you blend using the VARIABLE SPEED DIAL.

•       Ensure you do not exceed the BEAKER’S maximum capacity of 600ml.

BLENDER CUTS OUT DURING OPERATION.

|

•       The thermal cut-out switch has activated due to continuous usage. Unplug and allow the appliance to completely cool for 30 minutes before using again.

CUSTOMER SERVICES
If you are having difficulty using your product and require support, please contact hello@domu.co.uk

DISPOSAL INFORMATION

Please recycle where facilities exist. Check with your local authority for recycling advice.

WARRANTY

To register your product and find out if you qualify for a free extended warranty, go to: www.VonShef.com/warranty
Please retain a proof of purchase receipt or statement as proof of the purchase date.
The warranty only applies if the product is used solely in the manner indicated in this manual and all instructions have been followed accurately. Any abuse of the product or the manner in which it is used will invalidate the warranty.

Returned goods will not be accepted unless repackaged in their original packaging and accompanied by a relevant and completed returns form. This does not affect your statutory rights.
No rights are given under this warranty to a person acquiring this appliance second-hand or for commercial or communal use.

COPYRIGHT
All material in this instruction manual is copyrighted by DOMU Brands Ltd.
Any unauthorized use may violate worldwide copyright, trademark, and other laws.

Thank you for purchasing the 4-in-1 Hand Blender.
VonShef® is a registered trademark of DOMU Brands Ltd
Made in China for DOMU Brands Ltd M24 2RW.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>