Versa G088 Automatic Quad Watch Winder Instruction Manual
- June 5, 2024
- versa
Table of Contents
Versa G088 Automatic Quad Watch Winder
Feature
- Wind clockwise, counterclockwise, Auto(bi-directional) by operating the switch.
- TPD (Turns Per Day) 650TPD – 850TPD – 1050TPD – 1250TPD Please note that the watch winder will turn, rest, and turn again for each setting. The watch winder will not turn constantly to prevent over winding of your watch. This is the normal operation for the watch winder.
Operation
- Insert the adapter into the socket located on the product and plug it into the electrical outlet.
- Open the front cover, then use your index finger and thumb to hold the watch pillow from the two sides of the pillow hitch marked with two arrows. With some force, pull out the watch pillow.
- Place the watch on the pillow by pushing in the spring on the back of the pillow, then put your watch around the pillow and let go of the spring.
- Once the watch is on the pillow, place the pillow back into the winder. Push until you hear a click signifying that it is securely in the winder.
- Slide Power switch to start using the winder, and select clockwise, counterclockwise or Auto(bi-directional) winding direction.
Specification
- Power AC adapter DC/4V 550mA
- Size 9.45 x 10.20 x 7.72 inch (W x H x D)
- Weight About 4.034 Ib (without adapter)
- Temperature Operate between 41°F ~ 104°F
- Accessory AC adapter
Tips for your new watch winder!
All automatic watches have different TPD requirements but on average most automatic watches need a minimum of 650-1200 TPD. All of our watch winders are set to accommodate this minimum requirement. To find the right setting for your watch we recommend the following procedure:
- Manually wind the watch by turning the crown 20-30 times. The watch winder will not wind a completely dead watch.
- Set the winder to the lowest TPD setting and bi-directional rotation. Place the watch in the winder and make sure it is seated prop- erly and securely in the holder.
- Turn the winder on and periodically check to make sure the time is correct. Most automatics have a maximum of 40 hours of power reserve when fully wound so if the time is correct after 2 full days, this is the proper setting for your watch.
- Ir the time is incorrect, please set it to the next highest PD Setting and try again.
- It the time is incorrect, please set it to clockwise only and try again.
- If the time is incorrect, please set it to counter-clockwise only and try again.
- If the watch works while it is being worn but does not work in the winder, it may need to be serviced. When the watch is worn, the movements it experiences are not as smooth as in a watch winder, so while a watch may work when its worn it may not work when in the winder. Watch winders move very smoothly so if the lubrication inside the watch has congealed from not being in use, the watch may need to be serviced.
- If you still have problems or issues please feel free to contact us BelowriasT anot work on the setting listed below. If this is the case please contact us and we will try to e snne o mO Scott setting for your particular model.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>