VERSA TRAX OneTrax Bed Anchor Installation Guide
- June 14, 2024
- VERSA TRAX
Table of Contents
VERSA TRAX OneTrax Bed Anchor
Product Information
Specifications
- Model: OneTrax
- Base Material: Not specified
- Weight: Not specified
- Color: Not specified
- Torque Requirement: 55 ft/lb
- Drive Type: TP-50 (Torx Plus 50)
FAQ (Frequently Asked Questions)
Q: Can I use OneTrax on any vehicle?
A: The compatibility of OneTrax may vary depending on the make and model of
your vehicle. Please refer to the product documentation or contact our
customer support for specific compatibility information.
Q: What is the purpose of the filler piece?
A: The filler piece is designed to secure the OneTrax assembly in place and
provide additional stability.
Q: Do I need any additional tools for the installation?
A: You will need a torque wrench and a TP-50 (Torx Plus 50) drive to
properly install and tighten the OneTrax assembly.
INSTALLATION INSTRUCTION
- Step 1: Remove the factory bed bolt from the vehicle and prepare the OneTrax base to be installed.
- Step 2: Position the bolt in the slot.
- Step 3: Slide Bolt to the center of the OneTrax base.
- Step 4: Rotate the bolt to allow the flange cutout to be faced towards the opening of the slot.
- Step 5a: Insert the filler piece as shown.
- Step 5b: Insert the filler piece as shown.
- Step 6: Insert TP-50 (Torx Plus 50) drive.
- Step 7: Torque OneTrax assembly to 55 ft/lb. Filler piece will lock into place.
- Step 8: Connect/disconnect single stud L-series fitting as needed.
Website Link
Documents / Resources
|
VERSA TRAX OneTrax Bed
Anchor
[pdf] Installation Guide
OneTrax Bed Anchor, OneTrax, Bed Anchor, Anchor
---|---
|
VERSA TRAX OneTrax Bed
Anchor
[pdf] Installation Guide
OneTrax Bed Anchor, Bed Anchor, Anchor
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>