UNION Wireless Charger for Smartphones under QI-Standard User Manual
- June 5, 2024
- UNION
Table of Contents
UNION Wireless Charger for Smartphones under QI-Standard
Description:
Wireless charger for smartphones under the QI-standard. Easy to charge your phone without cables, just put your phone on the charging plate.
Specifications:
- Input: According to the printing on the back center of the charging plate.
- Output: 10W max.
Compatible with the QI-standard.
Package contents:
- Wireless charging plate
- Adapter or Power cable
Power Supply:
The charger is recommended to power by a qualified AC adapter.
Operation:
Connect the wireless charger to an outlet such as a qualified AC adapter, then
a Led light is lighted. Put your phone on the charging plate and the battery
starts to charge, the Led light blinks during charging. If the phone doesn’t
start to charge, please to reposition it.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The distance between user and products should be no less than 20cm