Harvest Nodestream Mini Unit User Guide

June 5, 2024
Harvest

Harvest-Nodestream-Mini-unit-logo Harvest Nodestream Mini Unit

Harvest-Nodestream-Mini-Unit-product

OVERVIEW

Thank you for choosing Harvest Technology
Please read these instructions carefully before using this product, and save this quick start guide for future use. See the User Manual for full details via the QR code on the back page.

Video and two-way audio streaming solution

In the Box

Nodestream Mini
The Nodestream Mini (NSM) is a video and audio streaming device that can be configured either as an encoder or decoder. Ensure adequate spacing to allow cooling air to travel through vents as shown by the arrows.

Rear Connections

User Interface

START UP

  1. Power on the device (from mains)

  2. Device Configuration (if required) Connect a monitor, keyboard/mouse An on screen GUI displays, for further information – see User Manual

  3. Press and hold VOL button (see next page) or select Launch Nodestream to start software

  4. NOTE: For encoders only, the software starts automatically if an external monitor is not connected.
    Blue PTT LED indicates the software is running.

  5. Refer to the Nodester application for device status and connection management

Typical Boot Sequence

OPERATION

Status LED
(Blue) Power On
(Green) Video Streaming
(Red) No Network

PTT (Push To Talk)

(Off) Software not running
(Blue ) Software running
(Green) Audio connection active, mic muted
(Red) Mic open

VOL (Volume)Harvest-Nodestream-Mini-unit-10

Troubleshooting

Issue Cause Resolution
Device not powering. AC or DC not connected. Faulty PSU. Confirm AC

connected to PSU (LED on PSU is illuminated).

Confirm DC connected correctly at rear of device.

Video sources not displaying. (When in encoder mode)| Source(s) not connected or powered on.| Confirm video source(s) connected and powered on.
No display output.| Video output device not connected or powered on.| Confirm video output device connected and powered on.
No network –

“Connecting to Nodestream server 0%” message displayed and status LED is red.

| No connection to server.| Check Ethernet cable or WiFi is connected.

Ensure required firewall ports settings are correct (see User Manual).

Check network settings, contact your network administrator to diagnose network issues.

Technology Park, 7 Turner Ave, Bentley WA 6102
Australia www.harvest.technology
All rights reserved. This document is the property of Harvest Technology Group. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopy, recording or otherwise without the written consent of the Group Chief Executive
Contact and Support support@harvest-tech.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Harvest User Manuals

Related Manuals