HARVEST TECHNOLOGY Nodestream RiS Nodecom Device User Guide

June 3, 2024
HARVEST TECHNOLOGY

TECHNOLOGY Nodestream RiS Nodecom Device
User Guide

Overview

Welcome to the Nodestream RiS Nodecom (NCMR)
Please read these instructions carefully before using this product, and save this quick start guide for future use. See the User Manual for full details via the QR code on the back page.
Two-way audio streaming solution

In the Box

Rear Connections

Ensure adequate spacing to allow cooling air to travel through vents as shown by the arrows

User Interface

Configuration

Via web browser

  1. Connect the RIS Nodecom device to your LAN via the Ethernet port and power the device
  2. Configure the IPv4 settings of a computer connected to the same network
    IP| 192.168.2.x
    ---|---
    Subnet| 255.255.255.0
    Gateway| 192.168.2.1
  3. Navigate to http://192.168.2.1 from a web browser and login with admin
    User| admin
    ---|---
    Pasword| admin
  4. When prompted, enter a new password
  5. Configure device network settings as provided by your Network Administrator
  6. Once connected and configured on your local network, the RiS Nodecom device will show online in the Harvest RiS Deliverer application and will be ready for connection to another device.

Due to the possibility of conflicting IP addresses, only 1 device can be configured at a time. Once network settings have changed, the device can remain connected
User Manual
**** Refer to the RIS Nodecom user manual for additional information.

  • RiS networks require specific port settings, see user manual for details
  • Devices need to be manually added to the Deliverer application. See Deliverer User Manual for more information

Operation

Status LED

AUDIO
INTERFACE NCMR
PTT (Push To Talk)

| (Off)| Software not running
---|---|---
| (Blue)| Software running
| (Green)| Audio connection active, mic muted
| (Red)| Audio connection active, mic open

VOL (Volume)

Factory Reset

Device will reset to factory default user login and network settings

|
---|---
https://qrco.de/bcmrFV| Contact and Support
support@harvest-tech.com.au

Troubleshooting

Issue Cause Resolution
Device not powering AC or DC not connected.
Faulty or incompatible PSU Confirm PSU in plugged in and AC supply on Confirm

USB-  cable is connected correctly  Test with alternative PSU
If using an alternative PSU ensure it meets required specifications, see User Manual
Network issue (Device showing “offline” in  Deliverer application)| Network not connected or out of range Network settings incorrectDevice IP address incorrect in Deliverer application| Check Ethernet cable or WiFi is connected Ensure antenna is  orrectly installed  Check network settings, contact your network administrator to diagnose network Confirm IP  ddress of device matches that set in Deliverer
Forgot login or networkdetails| N/A| Factory reset to defaults
(see “Factory Reset” on page 5)

Harvest Technology Pty Ltd
7 Turner Ave, Technology Park
Bentley WA 6102, Australia
www.harvest.technology
®All rights reserved. This document is the property of Harvest Technology Pty Ltd. No part of this publication may be reproduced, stored in a retrieval system or  ransmitted in any form or  by any means, electronic, photocopy, recording or otherwise without the written consent of the Managing Director of Harvest Technology Pty Ltd.
HTG-TEC-GUI-018_0

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals