HARVEST TEC 870 Scanner Remote Floor Switch Owner’s Manual
- October 27, 2023
- HARVEST TEC
Table of Contents
HARVEST TEC 870 Scanner Remote Floor Switch
INSTALLATION INSTRUCTIONS
-
Attach the harness from the 870 Scanner Remote Floor Switch to the port on the right side of the 860 Scanner.
-
Attach switch bracket to a location on the floor that is accessible to foot operation with hardware included.
OPERATION
Your 860 Scanner will operate in the same manner as it did before. Refer to your 860 Scanner Operators Manual for instructions and operation.
NOTE: There is no voltage/current in this system. The buttons are detected with an electrical “ground sense”. The switch is normally open and temporarily closed when the button is pushed. If the buttons do not work, check connectors and wire continuity with the appropriate meter.
PARTS
Warranty
Harvest Tec, LLC. will repair or replace components that are found to be
defective within 12 months from the date of manufacture. Under no
circumstances does this warranty cover any components which in the opinion of
Harvest Tec, LLC. have been subjected to negligent use, misuse, alteration,
accident, or if repairs have been made with parts other than those
manufactured and obtainable from Harvest Tec, LLC.
Our obligation under this warranty is limited to repairing or replacing free
of charge to the original purchaser any part that in our judgment shows
evidence of defective or improper workmanship, provided the part is returned
to Harvest Tec, LLC. within 30 days of the failure. Parts must be returned
through the selling dealer and distributor, and transportation charges
prepaid.
This warranty shall not be interpreted to render Harvest Tec, LLC. liable for
injury or damages of any kind, direct, consequential, or contingent, to
persons or property. Furthermore, this warranty does not extend to loss of
crop, losses caused by delays or any expense prospective profits or for any
other reason. Harvest Tec, LLC. shall not be liable for any recovery greater
in amount than the cost or repair of defects in workmanship. There are no
warranties, either expressed or implied, of merchantability or fitness for a
particular purpose intended or fitness for any other reason.
This warranty cannot guarantee that existing conditions beyond the control of
Harvest Tec, LLC. will not affect our ability to obtain materials or
manufacture necessary replacement parts. Harvest Tec, LLC. reserves the right
to make design changes, improve design, or change specifications, at any time
without any contingent obligation to purchasers of machines and parts
previously sold.
HARVEST TEC, LLC.
P.O. BOX 63
2821 HARVEY STREET
HUDSON, WI 54016
PHONE: 715-386-9100
1-800-635-7468
FAX: 715-381-1792
Email: info@harvesttec.com