LifThor Baldur2 for DJI Mavic AlR 2(s)/ Mini 2/Mavic 3 PRO User Manual
- June 5, 2024
- LifThor
Table of Contents
by Thor’s Drone World
User’s Manual
Congratulations on your new
The New & Improved Tablet holder for DJI Mavic AIR 2(s) / Mini 2 / Mavic 3 PRO
Content:
How to assemble:
*Note:
The aluminum base has pre-installed anti-slip pad to protect the RC from any
scratches and keep it secure in place.
Prepare the RC by extracting the antenna all the way out
Gently lower the RC into the bay of the base with a slight inclination. Aligning the RC center to the mount
Make sure the RC is aligned and centered properly
Reconnect the neck of the aluminum base between the antenna bars back to the main body.
Insert the star knob thumbscrew from below the utility mount through the small round hole.
If needed you can loosen up the utility mount using the hex key provided to adjust its angle.
Screw the universal clamp in place
The NEW universal clamp has two mechanisms to ensure your tablet sit
secure and in place.
The first mechanism is the ratchet part, it can be extended in 6 fixed
steps (3 on the top / 3 on the bottom) to adjust to the size of your tablet.
We recommend setting it a little smaller (1″ / 2.5cm) than the actual size of
the tablet for a tight, secure fit.
Press and hold the side buttons to extend the ratchet mechanism
Place the phone / tablet in landscape mode by pulling the spring mechanism upwards and release it to secure the device in place.
* It’s the spring-loaded part that will hold your device in place !
Compatible with most smart phones and tablets up to 12.9″
Minimum expanding 6.5cm Maximum expanding 23 cm
Alternative setups:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>