JMTek WPC100QI Qi Certified Wireless Charger Instruction Manual
- June 5, 2024
- JMTek
Table of Contents
WPC100QI Qi-Certified Wireless Charger
Instruction Manual
Please read the following carefully for information on the correct use of this device.
Package Content
- Wireless Charger
- USB A to Type-C fast charging cable
- User Manual
Specifications
- Input: DC 5V,2A/ DC 9V,2A
- Output: DC 5V,1A(5W)/ DC 9V,1.1A(10W)
- Charging Distance≤6mm
- Certification: Qi Certified
General information
- For normal operation, no weaker than DC 5V, a 2A charger is required.
- For a fast wireless charging mode, use the Quick Charger 2.0/3.0 compatible charger and compatible smartphones.
Instructions
Using the USB A to Type-C cable supplied insert the Type-C connector into the Type-C port on the charger and then insert the standard USB connector (another end of cable) into any standard USB charging port with a maximum approved power source of 5V,2A, or 9V,2A. Place your Qi compatible phone with inductive(wireless) charge feature onto the charger’s Charge Plate (back of the phone to charger) in either a horizontal or vertical position.
The height of the Charge Plate may need to be adjusted to align the Charge Plate with your phone’s charge area. Using the Height Adjustor button on the back of the charger lower or raise the Charge Plate until your phone show it is charging in the normal way.
Note- only devices which support Qi wireless charge technology can be
wirelessly charged from this charger, please check your device specifications.
Caution, only connect the charger to an approved charging device with a
maximum approved power source of 5V,2A, or 9V,2A, otherwise personal injury or
device damage may occur. Use either the charging cable supplied with the
charger or a certified fast charging cable. Do not drop, disassemble or modify
this product. Do not expose this product to fire or excessive heat. Do not
expose this product to water or excessive humidity. Do not put any bare metal
on the surface area of the wireless charger when it is operating.
FCC STATEMENT:
This device complies with part 15 of the FCCRules. Operations subject to the
following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur ina particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>