JMTek WPC901 Wireless Charger Instruction Manual
- June 5, 2024
- JMTek
Table of Contents
JMTek WPC901 Wireless Charger
Please read the
following carefully before using the device to ensure safe and proper use.
Package Content
- Wireless Charger
- USB A to USB-C fast charging cable
- User Manual
Specifications
- Input: DC 5V,2A/ DC 9V,2A
- Output: 5W/7.5W/1OW/15W
- Charging Distances6mm
General information
- This charger works with all Qi-compatible devices (please make sure your device is Qi-compatible)
- For normal operation, no weaker than DC 5V, 2A adapter is required.
- For fast wireless charging mode, use the QC 2.0/aC 3.0 or PD adapter and compatible smartphones.
- This wireless charger can charge smartphones with a non-metal protective case or silicone covers that are no thicker than 6mm.
Instructions
Connect the USB cable(included) to a power outlet rated at DC 5V/2A or 9V/2A,
the Type-C plug to the Type-C input of the wireless charger.
Place your Qi-compatible phone with an inductive (wireless) charge feature
onto the charger (back of phone to charger), then wireless charging of the
phone will start immediately.
Note- only devices which support Qi wireless charge technology can be
wirelessly charged from this charger, please check your device specifications.
Some phone cases do not support Wireless Charging due to the thickness and
design. If your phone is compatible with Wireless Charging and you are unable
to charge it wirelessly, please remove your phone case and retry.
Caution: Do not drop, disassemble or modify this product. Do not expose
this product to fire or excessive heat. Do not expose this product to water or
excessive humidity. Do not put any bare metal on the surface area of the
wireless charger when it is operating.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.If this equipment
does cause harmful interference to radio or television reception,which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20cm between the radiator & your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>