integral LED GU10 Wall Light Instruction Manual
- June 5, 2024
- integral LED
Table of Contents
integral LED GU10 Wall Light
OVERVIEW
INSTALLATION INSTRUCTION
| Product Code | 6 Digit Code | Wattage | Lumens Output |
|---|---|---|---|
| ILDEB032 | 61-16-66 | 1x max 5w LED GU10 | N/A |
| ILDEB033 | 90-23-03 | 2x max 5w LED GU10 | N/A |
Thank you for purchasing an INTEGRAL LED product. When installed correctly this unit will provide years of service – with no lamp changes required. For support or warranty information please see integral-led.com.
Important Details – Please read prior to installation
-
Installation must be completed by a qualified electrician in accordance with all recognized local and national electrical and construction regulations.
-
Ensure that the power is OFF during installation and that power cannot be unexpectedly reconnected.
-
The light fitting is designed to operate with a 220~240V 50Hz/60Hz electricity supply.
-
Do NOT use the luminaire if damaged
-
Where applicable, consideration should be taken to ensure all fixings are of suitable size for the luminaire to be installed.
-
This luminaire is rated at IP54, suitable for residential outdoor areas such as the garden, porch, garage and driveway. NOT suitable for water immersion. When installing the product ensure the supplied grommets and glands are used to protect the IP rating.
-
Do not cover the light source.
-
To avoid damage, DO NOT lift, carry or let the luminaire hang by any part of the wiring.
-
This product is Class I – Earth connection required.
-
Failure to comply with the recommendations and instructions provided herein may cause damage to the luminaire or present a risk of injury or death (e.g. short circuit, fire, burns or electric shock). Any modifications to the luminaire, incorrect installation or unfit positioning may be dangerous to users and may cause the warranty to become void.
Installation Instructions -
Ensure that the power is OFF during installation and that power cannot be unexpectedly reconnected.
-
Follow the steps as laid out in the figures.
-
Use suitable tools and fixings to mount the luminaire safely and securely to the surface. Depending on the substrate alternate fixings to the ones supplied may be required. Avoid any damage to any wiring.
-
Once the light fitting base is securely mounted, connect the mains supply to the connector. Please pay attention to the polarity. L=Live (Brown), N=Neutral (Blue), E=Earth (Green/Yellow). The luminaire is a CLASS I device – an EARTH connection is MANDATORY.
-
Check connections and switch power ON when safe to do so.
- NEUTRAL = BLUE
- LIVE = BROWN
- GREEN/YELLOW = EARTH
WARNING
WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL AUTHORITY FOR RECYCLING ADVICE.