Hunter 4016943 Lenlock One Light Wall Sconce Instruction Manual
- June 3, 2024
- Hunter
Table of Contents
4016943 Lenlock One Light Wall Sconce
Instruction Manual
For Models:
19902 19903
19904 19905
19906 19907
4016943 Lenlock One Light Wall Sconce
1 Light Wall Sconce
Fixture weight ±2 lbs:
Peso ±2 lb: 3.06 lbs (1.39 kg)
Poids fixe ±2 lbs:
Hardware Service Kit
Part| Model| Finish
KE99701214| 19902
19905| Brushed Nickel
KE99701834| 19903
19906| Noble Bronze
KE99701L24| 19904
19907| Palm Gold
Glass
Part #| Model| Type
KE30001045| 19902
19903
19904| Cased White Glass
KE30002046| 19905
19906
19907| Clear Seeded Glass
INSTALLATION INSTRUCTIONS
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.
- The lighting fixture must be grounded. If the ground wire for the installation site is not present, immediately STOP installation and consult a qualified electrician.
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that
they are read carefully and completely before beginning the installation of
the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the wall, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Pull the house wires through the center of the mounting plate (A). Secure the mounting plate (A) to the junction box by tightening the screws (B).
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach
the fixture’s wires to the power supply wires from the junction box. Connect
black to black (live); white to white (neutral);
grounding to grounding (green or copper). Twist the ends of the wire pairs
together. Then, twist on a wire connector. Make sure all twists are in the
same direction. Loop the fixture’s ground wire around the grounding screw (C)
and tighten it. If there is no ground wire (green or copper) from the junction
box, contact a qualified electrician.
FINISHING THE INSTALLATION
Place the fixture (E) over the mounting plate (A) making sure to align the
holes of the fixture with the holes of the mounting plate. Secure the fixture
with screws (D). Install the bulb according to the fixture specifications (not
included).
Do not exceed the recommended wattage. Lift the glass (F) and align the
notches in the glass with the tabs in the lamp cup (E). Attach the glass by
lifting and turning clockwise one-third of a full turn of the glass until it
stops. Turn on the power and test the fixture. For a vertical installation
make sure the mounting plate (A) has folded sides with drilled holes at the
top and bottom of the junction box. Your installation is now complete.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep
cleaning. For regular cleaning, turn off the light and wipe down the fixture
with a clean lint-free cotton or microfiber cloth. Never spray the cleaner
directly onto the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>