BOSCH SMH4HVX31E 60cm Fully Integrated Dishwasher User Guide
- June 5, 2024
- Bosch
Table of Contents
BOSCH SMH4HVX31E 60cm Fully Integrated Dishwasher
Setting up Home Connect
Tip: Connect your appliance to a mobile device. You can conveniently change all settings using the Home Connect app.
- Install the Home Connect app on your mobile device and follow the instructions.
- Scan the QR code with the Home Connect app.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected
here.
A table of country-specific units can be found in the instruction manual.
Setting the water softening system
-
Press .
-
To open the basic settings, press for 3 seconds.
a The display shows Hxx.
a The display shows . -
Press repeatedly until the right water hardness has been set.
-
To save the settings, press for 3 seconds
Adding special salt
To avoid damage to the appliance, only add special salt to the dispenser for special salt just before the
programme starts
- Unscrew the lid of the dispenser for special salt and remove.
- On initial start-up: Fill the dispenser right up with water.
- Add the special salt to the dispenser. The water in the dispenser is displaced and forced out. Never add detergent.
- Place the lid back on the dispenser and turn to close.
Adding rinse aid
- Press the catch on the lid of the dispenser for rinse aid and lift .
- Add rinse aid up to the max mark. max
- Close the lid of the dispenser for rinse aid. a The lid clicks into position.
Adding detergent
- Add the detergent to the dry detergent dispenser 15 ml 25 ml 50 ml 2. Close the lid of the detergent dispenser.
- a The lid clicks into position
How to use your appliance
- Load the tableware. Only clean tableware that is suitable for dishwashers. Remove large remnants of food from the tableware. Check that the spray arms can rotate freely.
- Add detergent.
- Switch on the appliance .
- Select the programme.
- Start the programme .
- Remove the tableware at the end of the programme.
- To cancel the programme, press for approx. 4 seconds.
The programme is cancelled and ends after approx. 1 minute.
Cleaning filters
- After each wash check the filters for residue.
- Turn the coarse filter anticlockwise and remove the filter system .
- Pull down the micro filter to remove.
- Press the locking catches together and lift the coarse filter out .
- Clean the filter elements under running water.
- Re-assemble the filter system.
- Insert the filter system into the appliance and turn the coarse filter clockwise. Make sure that the arrow markings match up.
Cleaning spray arms
- Unscrew the upper spray arm and pull down to remove .
- Pull up the lower spray arm to remove.
- Check the outlet nozzles on the spray arms for blockages under running water and remove any foreign bodies.
- Insert the lower spray arm. a The spray arm clicks into position.
- Insert the upper spray arm and screw it firmly in place.
Clean wastewater pump
- Disconnect the appliance from the power supply.
- Remove the filter system.
- Scoop out any water.
- Prise off the pump cover using a spoon and grip it by the crosspiece.
- Lift the pump cover inwards at an angle and remove.
- Remove any remnants of food and foreign bodies in the area of the impeller.
- Insert the pump cover and press down . a The pump cover clicks into position. 1
- Install the filter system.
Programmes
- The programme data has been measured in the laboratory according to
- European standard EN 60436.
- The consumption figures depend on the programme and additional function selected.
- The runtime will change if the rinse aid system is switched off or rinse aid needs to be added.
Troubleshooting
Read User Manual Online (PDF format)
Loading......