Hunter 19882 Nolita 3 Light Vanity Instruction Manual
- October 27, 2023
- Hunter
Table of Contents
Hunter 19882 Nolita 3 Light Vanity Instruction Manual
Product Descriptions
Specifications
3 Light Vanity
Fixture weight ±2 lbs: 6.2 lbs (2.81 kg)
Hardware Service Kit
| Part | Model | Finish |
|---|---|---|
| KE99701214 | 19881 | Brushed Nicke |
| KE99701L24 | 19882 | Palm Gold |
Glass
| Part # | Model | Type |
|---|---|---|
| KE29601045 | 19881 | |
| 19882 | Cased White Glass |
Required Tools
Here are the tools you’ll need to complete your installation:
Ladder
Screwdriver
Pliers
Wire Strippers
WARNING
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.
- The lighting fixture must be grounded. If the ground wire for the installation site is not present, immediately STOP installation and consult a qualified electrician.
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that they are read carefully and completely before beginning installation of the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the
circuit breaker and completely remove the old fixture from the wall, including
the old mounting bracket. Remove the new mounting bracket assembly from the
bag.
Place the mounting plate (A) over the junction box so that the folded sides
extend out away from the wall and the holes are top and bottom. Pull the house
wires through the center of mounting plate (A). Secure mounting plate (A) to
the junction box by tightening the screws (B).
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach the fixture’s wires to the power supply wires from the junction box. Connect black to black (Live); white to white (grounded); grounding to grounding (green or copper). Twist the ends of the wire pairs together. Then, twist on a wire connector. Make sure all twists are in the same direction. Loop fixture’s ground wire around grounding screw (C) and tighten. If there is no ground wire (green or copper) from the junction box, contact a qualified electrician.
FINISHING THE INSTALLATION
Place the fixture (E) over the mounting plate (A) making sure to align the holes of the fixture with the holes of the mounting plate. Secure the fixture with screws (D). Slide glass shade (F) over the socket followed by the socket cover (G) and secure with socket ring (H). Install light bulb (not included) in accordance with the fixture’s specifications. Do not exceed the recommended wattage. Turn on the power and test the fixture. Your installation is now completed.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>