DANCO 62068 4 Inch Steel Floor Register Instruction Manual
- June 3, 2024
- DANCO
Table of Contents
DANCO 62068 4 Inch Steel Floor Register
Instructions
Tools Required: Screw & Screwdriver (Not provided with kit)
-
Refer to your OEM instructions on how to safely remove the old floor register.
-
Remove your old floor register (A) and discard. Do not discard the old screws (B).
-
Measure your floor duct opening size (C).
-
Select the appropriate floor register for your need. Danco offers 4 different sizes.
Always choose a size slightly bigger than the duct opening itself. For example, if your duct size is 3 ½” X 9 ¼” then choose the 4” width X 9 ¾” length (62068). -
Install new register into your floor opening using the screws as shown on Image I.
Note: Some ducts don’t require the screws to hold register in place. If your duct opening doesn’t have screw holes, then simply set the register into the floor opening. -
Adjust the damper handle as desired
DIMENSION
Note : This dimension is what goes into the door duct opening
| Danco | Actual floor opening size | Overall front size | Depth |
|---|---|---|---|
| 62067 | 4″ width x 7-3/4″ length | 5-3/8″ width x 9-3/8″ length | 0.85″ |
| 62068 | 4″ width x 9-3/4″ length | 5-3/8″ width x 11-3/8″ length | 0.85″ |
| 62069 | 4″ width x 7-3/4″ length | 5-3/8″ width x 10-1/8″ length | 1.37″ |
| 62070 | 3-3/4″ width x 9-7/8″ length | 5-3/8″ width x 12-1/8″ length | 1.37″ |
©2022 Manufactured for Danco, Inc., Irving, TX 75062
62067i/62068i/62069i/62070i
Visit
DANCO.COM
for Easy D.I.Y. Solutions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>