nedis HTOI20EWT7 Mobile Oil Radiator Instruction Manual

nedis HTOI20EWT7 Mobile Oil Radiator

This product is only suitable for well-insulated spaces or occasional use.

Description

1. On/off button
2. Temperature button
3. Display
4. Handgrip
5. Ventilation openings
6. Support

Safety

General safety

• Read the manual carefully before use. Keep the manual for future reference.
• The manufacturer is not liable for consequential damages or for damages to property or persons caused by non-observance of the safety instructions and improper use of the device.
• The device can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and user maintenance shall not be made by children without supervision.
• Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
• Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
• The device is suitable for indoor use only. Do not use the device outdoors.
• The device is suitable for domestic use only. Do not use the device for commercial purposes.
• Do not use the device in locations with high humidity, such as bathrooms and swimming pools.
• Do not use the device near bathtubs, showers, basins or other vessels containing water.
• Do not use a timer or a separate remote-control system that switches on the device automatically.
• Do not cover the device.
• Do not block the ventilation openings.
• Place the device on a stable, flat surface.
• Place the device at least 1 meter away from the wall.
• Keep the device away from flammable objects (furniture, curtains, garments, etc.).
• Children of less than 3 years should be kept away.
• Do not locate the product immediately below a power outlet.

Electrical safety

• To reduce the risk of electric shock, this product should only be opened by an authorized technician when service is required.
• Disconnect the product from the mains and other equipment if a problem should occur.
• Do not use the device if the mains cable or mains plug is damaged or defective. If the mains cable or mains plug is damaged or defective, it must be replaced by the manufacturer or an authorised repair agent.
• Before use, always check that the mains voltage is the same as the voltage on the rating plate of the device.
• Do not move the device by pulling the mains cable. Make sure that the mains cable cannot become entangled.
• Do not immerse the device, the mains cable or the mains plug in water or other liquids.
• Do not leave the device unattended while the mains plug is connected to the mains supply.
• Do not use an extension cable.
• Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
• This heater is filled with a precise quantity of special oil. Repairs requiring opening of the oil container are only to be made by the manufacturer or his service agent who should be contacted if there is an oil leak.
• When scrapping the heater, follow the regulations concerning the disposal of oil.

Explanation of the safety symbols on the product

Installation

• Refer to the illustration to install the device.

Use

Initial use

Note: If you switch on the device for the first time, the device may emit a little smoke and a characteristic smell for a short period. This is normal operation.

Switching on and off

The device can be switched on to three power levels.

• To switch on the device, turn the on/off button to the “I”, “II” or “III” position. The display shows the power level.
• To switch off the device, turn the on/off button to the “0” position. The display goes off.

Setting the temperature

• Turn the temperature button clockwise to increase the temperature.
• Turn the temperature button counterclockwise to decrease the temperature.

Cleaning and maintenance

Warning!

• Before cleaning or maintenance, always switch off the device, remove the mains plug from the wall socket and wait until the device has cooled down.
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
• Do not immerse the device in water or other liquids.
• Clean the outside of the device using a soft, damp cloth. Thoroughly dry the device with a clean, dry cloth.
• Clean the ventilation openings using a soft brush.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>