NYXI Switch Pro Controller for Nintendo Switch Instructions
- June 5, 2024
- NYXI
Table of Contents
Switch Pro Controller
connect to Switch Console
Step 1: Go to System Settings—Controllers and Sensors—*Change Grip/Order.
Step 2: Hold down the “HOME” buttons and the 4 lights flash in turn. Wait
for a few seconds the controller will be paired with your console.
Reconnect
Hold down the “HOME” button to reconnect to your Switch console.
Power
Hold down the “Home” button for 5 seconds for the controller to power off
the controller.
Turbo
Turbo Buttons: X/Y/A/El/L✓It/ZL/ZR
Turbo Setting: Hold down one of the 10 buttons then press the “T” button to
activate the turbo function. Hold down the turbo button then press the “T”
button to clear the turbo function.
Continuous speed adjustment: press and hold the T key, control the right
rocker up and down, and select the appropriate gear. You can choose three
gears: slow, medium, and fast.
Vibration
After connecting the computer, press the Turbo key and the left 3D key to
adjust the motor vibration intensity. There are 4 levels of adjustment: 0 (to
turn off vibration) — 30% (weak) -70% (medium) — 100% (strong). And the
default is 70% (medium)
Weak: the motor shakes weakly two times
Medium: the motor shakes normally two times
Strong: the motor shakes strongly two times
Closed: the motor does not shake at all
Remark: handle vibration adjustment has a memory function
Calibrate Motion Controls/Control Sticks
You need to calibrate motion controls when the character/view moves
automatically. You need to calibrate Control Sticks when the joystick doesn’t
work properly.
Calibrate Motion Controls: System Settings→ Controllers and Sensors→
Calibrate Motion Controls→ Follow up the guide to calibrating.
Calibrate Control Sticks: System Settings→ Controllers and Sensors→
Calibrate Control Sticks→ Follow up the guide to calibrate.
Reset
Press the reset button (a small hole) on the back of the controller to reset
the controller.
Connect to PC
Connect the interface between the handle and the computer directly with the
USB data cable; The computer will prompt you to find the new hardware and
complete the installation. When the LED2 indicator light of the handle
flashes, it means the connection is successful.
Parameter
Working Voltage: 3.7V
Battery Capacity: 1500mAh
Input Voltage: 5V
Low Voltage Alarm: < 3.7V
Pairing Time: S. 10s
Reconnect Time: < 5s
Charging: 4 LED lights flash Fully
charged: 4 LED lights off
FCC Statement:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF warning for Portable devices:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>