Maisto 81791 Radio Control Vehicle User Guide

June 6, 2024
Maisto

81791 Radio Control Vehicle
User Guide

Maisto Radio Control Vehicles

please keep this owner’s instruction manual for future reference.
It contains important information.
We reserve the right to improve/revise the product specifications without notice.
Class 1 LED Product

Contents:
RC Vehicle x 1
Transmitter x 1
Owner’s Instruction Manual x 1

Battery Requirement:
Vehicle 4 x 1.5VAA” LR6/6 Batteries
Transmitter 2x 1.5V “AAA” LO3/O3 Batteries

Battery installation for the Transmitter(Refer to Diagram 1)

1 Use a screwdriver to loosen the screw on the battery cover and to open the battery cover (Screwdriver is not included)
2.Install 2 new 1.5V “AAA” LR03/O3 batteries wit correct polarity (+/-) as shown inside the battery compartment
3Install the battery cover and then tighten the screw on the battery cover

Battery installation for the Vehicle:(Refer to Diagram 2

  1. Set the “power switch” on the vehicle to the OFF position.
  2. Use a screwdriver to loosen the screw on the battery cover and to open the battery cover (Screwdriver is not included)
  3. Install 4 new 1.5V “AA” LR6/6 batteries with correct polarity (4/-) as shown inside the battery compartment
  4. Install the battery cover and then tighten the screw on the battery cover

How to play: (Refer to Diagram 3, 4, 5 & 6)

  1. Pull and discard plastic strip in the vehicle before the first play

  2. Set the “Power Switch” on the controller and vehicle to ON position, the power LED” on the controller and the LED on the vehicle will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed

  3. If the “Power LED” of the controller or the LED of the vehicle flash more than 3seconds, switch off both the vehicle and controller, then turn them on again

  4. Pull the trigger in the transmitter to drive the vehicle forward Push the trigger in the transmitter to drive the vehicle backward
    Maisto 81791 Radio Control Vehicle - 4

  5. Turn the steering knob on the transmitter to steer the vehicle to right or left

  6. The LED on the vehicle will light up when the vehicle power is turned on. After the frequency matching is completed, press the top button on the controller of press the front part of the vehicle to have different LED shows

  7. When the power switch of the vehicle is on OFF/Try Me position, press the front part of the vehicle to have different LED shows. The LED will get into power-saving mode if without pressing more than 6 seconds, then press the vehicle again can resume play LED shows

  8. If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis

  9. Turn the switch of the controller and vehicle to OFF position when not in play

Performance Tips:

  1. Do not drive the vehicle on grass, sand, or go through water

  2. Do not drive the vehicle in windy or rainy weather

  3. Do not drive the vehicle into any hard object

  4. Keep fingers, hair, and loose clothing away from the vehicle

  5. The operating range can be affected by a variety of factors
    a) Weak transmitter or vehicle batteries
    b) Interference from other items that emit radio frequency signals such as another RIC item on the same frequency, CB radios, cordless phones, high voltage transmitters, etc

  6. Outdoor usage is recommended in order to get optimal control range

Battery use:

  1. Alkaline batteries are recommended
  2. Only batteries of the same or equivalent type as recommended are to be used
  3. Do not mix alkaline, standard, or rechargeable batteries
  4. Do not mix old and new batteries or different types of batteries
  5. Non-rechargeable batteries are not to be charged
  6. Rechargeable batteries are only to be charged under adult supervision
  7. Rechargeable batteries are to be removed from the product before they are charged
  8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
  9. Remove all batteries from the product when not in use for a long period of time
  10. Exhausted batteries are to be removed from the product
  11. The supply terminals are not to be short-circuited
  12. Dispose of batteries properly. Do not dispose of batteries in a fire – it may cause them to explode or leak causing injury or damage
  13. Battery change must only be made by adult

Cautions

  1. Do not attempt to disassemble the products.
  2. Do not operate the vehicle with the same frequency as other players in the same location. This will interfere and cause the vehicle to lose control.
  3. Make sure the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
  4. Remove the package, take out all accessories and assemble the product before giving it to children to play with.

FCC Label Compliance Statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation
    Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation f this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
    – Reorient or relocate the receiving antenna
    – Increase the separation between the equipment and receiver
    – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
    – Consult the dealer or an experienced radio/TV technician for help
    Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Troubleshooting:

Problem Cause Correction
No Function Low battery level

Battery polarities are reversed
The wheels are obstructed by foreign objects| Replace with new batteries
Insert the batteries with correct polarities as shown on the battery compartment
Remove foreign objects on the vehicle/wheels
Drive Slow /
Poor Turning Signal| Low battery level
The wheels are obstructed by foreign objects| Replace with new batteries
Remove foreign objects on the vehicle/wheels
Poor distance control| Low battery level
Strong interference of surroundings| Replace with new batteries
Move to a better location for playing

Disposal of batteries

Batteries should not be disposed of in household waste. As the consumer, you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold

You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb- Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury

Warranty

All Maisto RC products have 30 days limited warranty in function and performance You may receive a new replacement product if the defective product is returned to Maisto freight prepaid and confirmed a factory defective Maisto’s 30 days warranty is limited to factory defects in material and workmanship only. The warranty does not cover unauthorized modification, accidents, abusive use, and consequential damages per our judgment The warranty is limited to the original purchaser with dated proof of purchase only. If you have a problem with our product, e-mail or call customer service first_RA # may be issued if the problem cannot be resolved over the phone or email Return for repair or replacement must be shipped prepaid/postage prepaid and insured, include dated proof of purchase, RA# and a brief description of the problem. If the product is returned without a dated proof of purchase, it will be excluded from the coverage of this warranty Allow 3 to 5 weeks for delivery of repaired or replacement per Maisto’s discretion. Delivery is limited in the U.S.A. or Canada only. Warranty is only valid for purchases in U.S.A and Canada only. Check the FAQ section before you return the product to Maisto

FAQ (Frequently Asked Questions) 1)Why doos my R/C Vohiclo not start?

Make sure the frequency of the vehicle and transmitter are matched.
Check to make sure the batteries are not drained.
Make sure the batteries are installed per polarity indicators.
Make sure all the wheels are not obstructed by any foreign objects.

Why doos my R/C Vohiclo make unusual noises?
Check to make sure the batteries are not drained
Check to make sure all the wheels are not obstructed by any foreign objects

What if I’m still having a problem?
Check the FA and make sure all attempts have been made to make the unit work_ Check your purchase receipt date and make sure it’s within the 30 days warranty period at the time you intend to send it back. Contact Maisto (see below), and tell us the model that you have, the problem(s) you are having, your daytime phone number, and any other information that might be helpful for us to resolve the problem If Maisto cannot solve your problem by mail, email or telephone, we will issue a return authorization number so you can return the unit to us for repair or replacement No returns will be accepted without a return authorization (RA) number issued by Maisto clearly marked on the outside of the package Pack the unit back in its original box or another box with sufficient protective material, include a copy of your dated store receipt and a description of the problem then send it to freight prepaid to the address which we will provide when we issue the RA number.

Please refer to the FAQ section on our website for more information.
Website www.maisto.com
Email. customerservice@MayCheongGroup.com
Phone(909) 357-7988
830 a.m,-500 p.m./ Monday-Friday / Pacific Time
Maisto International, Inc., Fontana, CA 92336, US.A

www.maisto.com
MADE IN CHINA

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals