KLARSTEIN 10031891 KRISTALL Ice Cube Maker Instruction Manual

KLARSTEIN 10031891 KRISTALL Ice Cube Maker

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Check that the mains voltage corresponds to the rating of the appliance before operating.
• Use handles or knobs when moving. Place on a flat stable surface for use. Do not use outdoors.
• Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
• Unplug from socket outlet when not in use.
• To protect against electric shock, do not immerse cord or plug in water or any other liquid.
• The use of accessory attachments not recommended by the appliance manufacturer may cause injury.
• Do not locate this appliance immediately below a socket outlet.
• Do not allow cord to overhang the countertop where it can be easily pulled by children.
• Do not use this appliance for anything else other than its intended use.
• Do not overfill as this may cause a hazard. Ensure lid is closed when in operation
• To remove plug from outlet, do not pull on supply cord. Grasp plug firmly and pull to remove.
• No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling. This appliance is for household use only
• This appliance is not intended to be operated by means of an external timer or separate remote control system.
• This appliance is not intended to be immersed in water.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
• Please according to local regulations regarding disposal of the appliance for its flammable blowing gas.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• Fill with potable water only.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

This appliance contains the coolant isobutane (R600a),a natural gas which is environmentally friendly. Although it is flammable, it does not damage the ozone layer and does not increase the greenhouse effect. The use of this coolant has, however,led to a slight increase in the noise level of the appliance. In addition to the noise of the compressor,you might be able to hear the coolant flowing around the system. This is unavoidable and does not have any adverse effect on the performance of the appliance. Care must be taken during the transportation and setting up of the appliance that no parts of the cooling system are damaged. Leaking coolant can damage the eyes.

WARNING
Danger from fire/flammable materials. Please observe the local regulations for the disposal of units with flammable refrigerants and gases.

• Keep ventilation openings in the unit housing free of obstacles.
• Do not damage the refrigerant circuit.
• Do not use any mechanical devices or other means to accelerate the defrosting process or the ice recovery process.
• Do not use other types of electrical appliances inside the ice cube machine.

Special Notes

• When positioning the unit, make sure that the power cord is not pinched or damaged.
• Make sure that there are no multiple sockets or power supplies on the back of the unit.

To avoid contamination of food, please follow the instructions below:

• Regularly clean surfaces that may come into contact with food. Clean the water drain regularly.
• If the appliance contains a water tank, clean it if it has not been used for 48 hours. Rinse the tank if no water has been removed for 5 days.

WARNING
When using, servicing and disposing of the unit, pay attention to the left symbol on the rear of the unit or on the compressor. This symbol warns of possible fi res. There are fl ammable substances in the refrigerant lines and in the compressor. Keep the appliance away from sources of fi re during use, maintenance and disposal.

PRODUCT DESCRIPTION

1. Rear Cover
2. Condenser
3. Top Cover
4. Water Drain
5. Evaporator
6. Transparent Water Box
7. Ice board
8. Ice Basket
9. Floater switch
10. Water Temperature Sensor
11. Baseboard
12. Compressor
13. Power Cord
14. Transparent Water Box Cover
15. Control Panel

USE AND OPERATION

Installation

The machine should be upright to place on the horizontal plane. To ensure the machine ventilate normally, it is important to set 150mm room on top, sides and back. Do not place the machine next to the roast oven, radiate or other heat objects.

Control Panel

Buttons and Indicator Lights

Operation

1. Open the cover, and add water to a reservoir.
   NOTE: There is a hole on the water box, which is the maximum water level, water adding do not exceed it. If the water exceed, it will drain out. Suggest the water add under the hole, then put the water box into proper position, and cover it.

2. Connect the power, press the POWER key and then the machine enters standby state.

3. Select the desired ice size, the default size of machine is large one.

4. Press START key to start work.

Important Notes

• The water poured into water reservoir should be lower than the water reservoir’s MAX position. When water volume goes beyond the max, please open the bottom water drain plug to drain the spare water out. Then close the transparent lid.
• Please select the small ice when ambient temperature is below 15°C. When the ambient temperature is higher than 25°C, Large ice cube sizes are recommended.
• When the ice basket is full please remove the ice immediately, Do not allow the ice Basket to overfill. When the ice basket is full enough, you can take out the up water box, and take out a part of ice, you can take out the ice basket.
• Before making ice, do put the ice basket in the ice maker.

CARE AND CLEANING

• Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• To ensure the cleanness of ice, please change water for water reservoir at least once one day. If do not use for a long time, please drain the water out and clean it up.
• If the compressor takes a strike action for shortage water, fully water or interruption of power supply, it will delay for 3mins to start up after restarted.
• Always use fresh water before starting ice production either at initial installation or after a long shut-off period.

TROUBLESHOOTING

normal.
Indicator light of lack of water on| Water of Water box is not much enough.| Add enough water toWater box.
The floater is not installed

right.

| Call the service centre.
Der Schwimmer-Schalter

ist kaputt.

Indicator lights on display are not on.| Blown fuse/ No power.| Replace fuse / Turn power on.
Problem| Possible Cause| Suggested Solution
---|---|---
The Ice made is too large and with pieces sticking together.| Water temperature is too low.| Select small size.
Ice of previous cycles left in the water tray.| Take out the ice under the standby state.
The program of making ice is correct, but no ice come out.| No coolant in compressor.| Call the service centre.
Compressor is damaged.
Fan motor is damaged.
All indicators twinkle simultaneously.| The ice is not access to ice board.| Unplug the power and plug again to restart the machine.
The movable detect device the ice board is damaged.| Call the service centre.
The ice is full to reach the ice board, but no full indicate.| The movable detect device the ice board is damaged.| Call the service centre.
The indicate light is damaged.

Important Notes

• It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot.
• Due to fast freezing, ice cubes may appear “Cloudy”. This is air trapped in the water and will not affect quality or taste of ice.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>