KLARSTEIN 10032893 Fireplace Heater Instruction Manual

June 5, 2024
Klarstein

KLARSTEIN 10032893 Fireplace Heater

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following hints to avoid damages. Any failure caused by ignoring the items and cautions mentioned in the instruction manual are not covered by our warranty and any liability. Scan the QR code to get access to the latest user manual and other information about the product.

TECHNICAL DATA

Item number 10032893 10032974
Power supply 220-240 V~ 50 Hz
Power input 1850 W

SAFETY INSTRUCTIONS

When using any electrical appliance, basic safety precautions should always be followed including the following.

  • Check that the voltage of the main circuit corresponds with the rating of the appliance before operating.
  • Please ensure that the appliance is used on a stable, level, and heat resistant surface.
  • DO NOT immerse cords, plugs or any part of the appliance in water or any other liquid.
  • DO NOT leave the appliance unattended while it is operating.
  • Close supervision is necessary when any appliance is used by or near children.
  • Take care when any appliance is used near pets.
  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
  • Children should not play with the appliance.
  • Cleaning and user maintenance should not be undertaken by children without supervision.
  • Switch off at the wall socket then remove the plug from the socket when not in use or before cleaning.
  • If the supply cord or appliance is damaged, stop using the appliance immediately and seek advice from the manufacturer, its service agent or a similarly qualified person.
  • DO NOT let the cord hang over the edge of a table or counter or let it come into contact with any hot surfaces.
  • The use of accessory attachments other than those supplied is not recommended.
  • DO NOT pull the plug out by the cord as this may damage the plug and/or the cable.
  • DO NOT use this product for anything other than its intended use.
  • This appliance is for household use only.
  • DO NOT carry the appliance by the power cord.
  • DO NOT use any extension cord with this appliance.
  • DO NOT use the appliance outdoors.
  • This heater is not equipped with a device to control the room temperature. DO NOT use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
  • Always ensure that the heater is placed on a firm level surface.
  • Ensure that the heater is not positioned close to curtains, furniture or any combustible materials as this could create a fire hazard.
  • Never sit or stand on the fire.
  • Never cut off the plug and hard wire into a fixed fused spur.
  • The heater must not be located immediately below a mains socket outlet.
  • DO NOT cover the heater as this may lead to a fire risk.
  • DO NOT obstruct any of the openings of the heater.
  • DO NOT insert any object through any openings on the heater.
  • Check the heater from time to time for accumulated dust.
  • DO NOT use the heater in areas where flammable liquids are stored or where flammable fumes may be present.
  • DO NOT cover the cord under the carpeting. DO NOT cover with throw rugs, runners or the like. Arrange the cord away from traffic areas and where it could be tripped over.
  • This appliance has hot and arcing or sparking parts inside.
  • DO NOT use it in areas where gasoline, paint or flammable liquids are used or stored.
  • This fireplace should not be used as a drying rack for clothing. DO NOT hang
  • Christmas stockings or other decorations on or near this product.
  • DO NOT operate the heater on a timer, or leave on overnight.
  • When not being used, please unplug the heater from the mains socket.
  • Keep the mains lead away from the hot body of the heater and ensure that it is not pulled tight between the socket and the heater.
  • Always unplug the heater and allow it to cool before moving it from one location to another.
  • WARNING! This product must be installed correctly, failure to do so may cause damage to your product and/or your surroundings.
  • DO NOT attempt to dismantle or repair any part of the heater.
  • This should only be done by a qualified service agent.
  • In the unlikely event the appliance develops a fault, stop using it immediately and seek advice from the Customer Support Team.

CONTROL PANEL

Insert plug into mains socket Select the desired functions

Switch Description Function

1

|

O/I

| Switches on/off electricity supply to the heater

and flame effect.

Note: This switch must be in the ON (I) position for heater to operate with or without heat.

2| I| Switch on/off 900 W heat output.
3|

II

| Switch on/off 1800 W heat output. . (with switch 2 turned on)

4

|

Rotate thermostat knob

| The flame effect can be operated with or without

heat.

Rotate thermostat knob (4) clockwise or anti- clockwise to increase or decrease desired room temperature setting.

Safety cut-off
This appliance is fitted with a safety cut-off which will operate if the heater overheats (e.g. Due to blocked air vents). For safety reasons, the heater will NOT automatically reset. To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes. Reconnect the supply to the mains and switch on the appliance.

MAINTENANCE

Before cleaning or maintenance operation, switch off and unplug the appliance. Ensure it is perfectly cooled. To remove the dust, wipe the appliance with a cloth.
Never use abrasives or detergents.
Bulb replacement
Unplug from mains supply. Loosen the screws that fixed the back metal cover. And then take off the back metal cover. The G9 halogen bulb is located underneath (see the figure below). Remove the defective bulb by pulling it out of the lamp holder, replace with a 25W G9 halogen bulb. Take care not to touch the bulb with bare hands and ensure that the bulb is pushed home. mTo reassemble, follow the above instructions in reverse order.KLARSTEIN
-fig2

TROUBLESHOOTING

Symptom Solution
No light from the fuel effect. Possibly a bulb failure. Remove the faulty

bulb as detailed above and check it in

a table lamp that is known to work.

No heat or light.| Check the wall socket by plugging in a known working appliance.

If socket is functional, and cord or plug is sus- pected, have them checked by an electrician

Symptom Solution
Light but no heat Check that the Thermostat on the heater is set above the

ambient room temperature.

Alternatively, the automatic cut-off may have engaged – see Safety Cut-Off section

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service. This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited Unit 6 Riverside Business Centre Brighton Road Shoreham- by-Sea BN43 6RE United Kingdom

Information requirements for electric local space heaters

Model identifier(s): 10032893 10032974
Item Symbol
Heat output  

only
Nominal heat output| Pnom| 1.85| kW|  | manual heat charge control, with integrated thermostat| no
Minimum heat output (indicative)| Pmin| 0.95| kW|  | manual heat charge control with room and/or outdoor temperature feedback| no
Maximum continuous heat output| Pmax| 1.85| kW|  | electronic heat charge control with room and/or outdoor temperature feedback| no
Auxiliary electricity consumption|  | fan assisted heat output| no
At nominal heat output (fan motor)| elmax| 0.012| kW|  | Type of heat output/room temperature control
At minimum heat output (fan motor)| elmin| 0.012| kW|  | single stage heat output and no room temperature control| no
In standby mode| elSB| 0| kW|  | Two or more manual stages, no room temperature control| no
 |  | with mechanic thermostat room temperature control| yes
 | with electronic room temperature control| no
 | electronic room temperature control plus day timer| no
 | electronic room temperature control plus week timer| no
 | Other control options (multiple selections possible)
 | room temperature control, with presence detection| no
 | room temperature control, with open window detection| no
 | with distance control option| no
 | with adaptive start control| no
 | with working time limitation| no
 | with black bulb sensor| no
Contact details| Chal-Tec GmbH, Wallstraße 16, 10179, Berlin, Germany

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals