KLARSTEIN 10032944 Turbohybrid Vacuum Cleaner Instruction Manual

www.klarstein.com
TURBOHYBRID
Vacuum Cleaner
10032944

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following hints to avoid damage. Any failure caused by ignoring the items and cautions mentioned in the instruction manual is not covered by our warranty and any liability. Scan the QR code to get access to the latest user manual and other information about the product

https://use.berlin/10032944

TECHNICAL DATA

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.

Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

SAFETY INSTRUCTIONS

• Read all instructions before using the vacuum cleaner and save them for future reference. To reduce the risk of personal injury or damage to your vacuum, use only recommended accessories.
• Do not leave the vacuum unattended when it is plugged in and/or operating. Unplug the unit when not in use.
• Never operate this unit when flammable materials or when vapors are present because electrical devices produce arcs or sparks that can cause a fire or explosion.
• Always disconnect the plug from the wall outlet before removing the tank cover.
• Do not allow it to be used as a toy. Close attention is necessary when the vacuum is in use by or near children.
• Use only as described in this manual. Use only the manufacturer’s recommended attachments.
• Do not use with a damaged cord, plug, or other parts.
• If your vacuum is not working as it should, has missing parts, has been dropped, damaged, left outdoors, or dropped into water, call customer service.
• Sparks inside the motor can ignite flammable vapors or dust. To reduce the risk of fire or explosion, do not use near combustible liquids, gases, dust, gasoline or other fuels, lighter fluid, cleaners, oil-based paints, natural gas, coal dust, magnesium dust, grain dust, aluminum dust, or gun powder.
• Do not pull or carry the appliance by a cord, close a door on the cord, or pull cord around sharp edges or corners.
• Do not unplug by pulling on the cord. To unplug, grasp the plug firmly.
• Do not handle plug or appliance with wet hands.
• Do not put any object into ventilation openings. Do not vacuum with any ventilation openings blocked; keep free of dust, lint, hair, or anything that can reduce airflow.
• Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
• Turn off the control before unplugging.
• Use extra care when cleaning stairs.
• Do not use it to pick up flammable or combustible liquids such as gasoline or use it in areas where they may be present.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Do not use without filters in place.
• Always unplug this appliance before connecting or disconnecting the vacuum hose.
• Store the vacuum indoors. Put the vacuum away after use to prevent tripping accidents.

PRODUCT OVERVIEW

1. Switch button on the handle
2. Handle assembly
3. Release button of handy vac
4. Accessories
5. Switch button on handy vac
6. VC Body assembly
7. Dust cup
8. Front decorative block on handy
9. Electrical brush assembly
10. Charging base
11. Charger

ASSEMBLY

1| | Install the charging station closely
---|---|---
2| | Install the electrical brush by carefully inserting it into the vacuum compartment.
3| | Position the charging station close to a mains socket (well away from heat sources or wet places). Insert the adaptor into the main socket and connect the charging station.

CHARGING THE VACUUM CLEANER

Note: Before using your vacuum cleaner for the first time, charge the vacuum cleaner for approximately 5hours. A fully charged battery will give approximately 30~50mins of continuous vacuum cleaning.

1. Put the base on a flat, horizontal, stable surface that is not exposed to direct sunlight or humidity, and is far from any heat source.
2. Make sure the appliance is set to off, put the charger into the base, then, plug it into a wall socket.
3. The LED light on the handy vac will start blinking to show that the battery is charging, when the battery is fully charged, the LED indicator light should glow solid white (No longer blink)

Notes and tips

• The Charger might warm up during charging, this is normal, it will cool down as soon as the charging process is over
• When you notice the motor is turning less quickly, it means that the battery needs to be changed completely.
• It can be useful from time to time (Once a month) to completely discharge the battery, and then completely recharge it, to maintain optimal performance.
• Recharge after every use
• When starting to charge the battery, The LED Light starts to flash, after the electricity is full, the three lights will keep bright for 50 seconds, afterwards, the LED lights will turn off automatically.

Notice About Discharging

The light keeps blinking if the battery is with full electricity, when the battery is discharged, the lights will turn off gradually till the last light is extinguished.

Note: During discharging process, If the battery’s surface temperature exceeds 70℃, the light will keep blinking for 5 seconds, afterwards, the battery will enter into a self-protection procedure, and the battery will cut off the electricity to the main vacuum cleaner. When the battery’s surface temperature goes back to 65℃, the battery could work again.

OPERATION

• Once your appliance is fully charged. Remove it from the base, and hold it by its handle.
• Switch it on by pressing the switch button on the handle or handy vac for the cleaning job.
• After completing the cleaning job, press the switch button on the handle or handy vac to switch off the appliance, before putting it back into the charging base.

Note: there are two working speeds for this appliance, after the first switch is on, it will run at low speed. After twice pressing the switch button, the appliance will run at high speed.

Using the accessories

• Use the motorized brush to clean floors and carpets.
• There are crevice nozzles and a small brush as accessories at the backside of the handle part, install the nozzle firstly, then install the small brush into the crevice nozzle as below picture for cleaning narrow, hard to reach places, etc.
• You should regularly check that brush and accessories are cleaned after the next time use.

Notes: Remove accessories before attempting to place the vacuum cleaner back into its base, after use, you can store the accessories in their storage on the back side of the body.

CLEANING AND CARE

Cleaning the dust container, filters, and brush after each use is extremely important as it allows for optimal use of your appliance and eliminates the unpleasantness of bad smells.

Cleaning of the dust container and filters

1. Remove the whole dust container by pressing the release button
2. Pull out the filters and empty the contents of the dust container into the dust bin properly. The filters can be rinsed with warm water if necessary. Make sure that filters are completely dry before assembling again.
3. Re-install the components as below steps: Firstly, Put the cyclone cover into the dust cup, then, re-stall the filters (centrum filter, combed cotton) into the cyclone cover as below picture. Secondly, Install the dust container following up the opposite procedures as detaching the dust container.

Cleaning the roller brush

• If the roller brush becomes blocked or jammed for any reason, the vacuum pressure will be lower. The roller brush may then need to be cleaned.
• First, turn off the appliance, then, disconnect the brush from the whole unit. You can see the bottom of the brush as below, take one small tool like a pair of scissors or a sharp knife to remove any items such as threads that may have become entangled.
• If the roller brush needs to be taken out for cleaning, push the slip button on the bottom of the brush with a finger or a coin, remove the slip button as below picture, take out the roller brush for cleaning, and afterward, Put the slip button on roller brush and lock it by finger.

Note: Keep the range button within your eyesight and keep it out of reach of children.

HINTS ON DISPOSAL

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>