Klarstein 10029428 HIGHWIND Tower Fan User Manual

HIGHWIND
Tower Fan
10029428

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damage. We assume no liability for damage caused by disregard of the instructions and improper use.
Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10029428

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and contact qualified personnel only.
• packaging materials (plastic bags, polystyrene, staples, etc.) Must be kept out of the reach of children as they could be hazardous.
• This device may be only used by children 8 years old or older and persons with limited physical, sensory, and mental capabilities and/or lack of experience and knowledge, provided that they have been instructed in the use of the device by a responsible person who understands the associated risks.
• Before connecting the appliance, check that the appliance rating corresponds to the mains rating.
• This appliance must only be used for the purpose for which it has been manufactured. As a stand fan. The manufacturer is not responsible for any damage caused by improper or incorrect use.
• The installation/assembly of the device will be made according to the indications of the manufacturer. A wrong procedure may cause damage to persons, animals, or objects, for which the manufacturer cannot be considered responsible
• Before cleaning or carrying out maintenance on the appliance, disconnect it from the electrical mains by removing the plug from the electrical outlet or by switching off the system switch.
• If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If the above is disregarded, the safety of the appliance may be compromised.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
• Do not power the device using multiple sockets.
• Do not use adapters and/or extension cable
• The device must not be switched on using external timers and/or other remote control devices which are not specified in this manual.
• Do not use or store the device near heat sources (heaters, stoves).
• Do not dip the device in water or other liquids; in case of an accidental fall in the water do not try to take it out, but first of all unplug immediately the power cable from the socket.
• If you use the device for the first time, make sure to remove any label or protective sheet which blocks its proper functioning.
• Plug and unplug the power cable with dry hands and hold it firmly.
• Before plugging the plug into a wall outlet, make sure that the unit is switched off.
• Always unplug the power cable to avoid overheating and avoid stretching it.
• Make sure that all air intakes and outlets are free and not covered so that the unit does not overheat.
• Avoid placing the power cable on abrasive or sharp surfaces or in positions where it can be damaged easily.
• Do not hang the fan on the wall or ceiling unless this type of installation is provided and explained in this manual.
• Place the device at a proper distance from the objects or surrounding walls making sure that its functioning will not cause accidental damage.
• Do not use the device near gas stoves or open flames in general.
• Do not use the device near curtains or textiles.
• Do not cover the device during functioning.
• Do not expose yourself for a long period to the airflow generated by the device because it can cause damage to the health
• If the fan must be stored for a long period and is not used regularly, place the fan in its original packaging in a dry place.
• Always remember to unplug the power cable of the device if it is not used for a long period, before storing, cleaning, or performing any maintenance operation.
• Do not use the appliance in the presence of potentially flammable or explosive liquids or gases.
• This product is intended for household use only and not for commercial/industrial or outdoor use.

DEVICE OVERVIEW

1 Control panel
2 Display
3 Front cover
4 Rear cover
5 Protective grille
6 Column
7 Stand
8 Remote control|
---|---

INSTALLATION

1. Remove all parts of the device from the packaging.

2. Lay the power cable through the middle of the two stand parts.

3. Assemble the stand. To do this, hook one part of the stand into the brackets of the other part.

4. Turn the body of the tower fan upside down. Place the stand on the body.
   Make sure that the column is firmly seated in the stand.

5. Screw the stand onto the column using the screws provided.

6. Route the power cable through the guide on the back of the body.

7. Put the tower back in place. The unit is ready for use.

OPERATION

Operation via the control panel on the device

1| Activate the timer. Each time the key is pressed, the time is increased by one hour.
---|---
2| Deactivating the timer.
3| Selection of three modes (Sleep, Nature, Normal). The selected mode appears in the display.
4| On/Off switch
5| Selection of three levels (low, medium, high). The selected level appears in the display.
6| On/Off switch for swivel movement

Display field

REMOTE CONTROL

Notes on the remote control

• Hold the remote control in the direction of the infrared receiver on the unit.
• Do not block the line of sight between the remote control and the receiver.
• Do not use the remote control in a room where heavy machinery is running.
• Handle the remote control with care. Do not drop the remote control on the floor. Do not strike it against hard objects.

Notes on the batteries

• Remove the batteries from the battery compartment if you will not be using the remote control for an extended period of time.
• The remote control requires three micro batteries (LR03). They should be new and replaced at the same time when they are empty.
• Before inserting them, clean the contacts on the batteries and in the battery compartment.
• Pay attention to the correct polarity when inserting them. Plus and minus must match the drawings on the battery compartment.

CLEANING AND MAINTENANCE

Note: Do not allow water to run inside the unit.

Cleaning

| 1. Always unplug the power cord before cleaning.
2. Remove dust by vacuuming along the front of the fan and at the back where the plastic grilles cover the air intake. Pipe cleaners or feather dusters are also suitable.
3. Wipe the surface of the fan occasionally with a damp cloth (not dripping) and dry the surface thoroughly with a soft, dry cloth before operating the unit.
4. Do not use harsh cleaners or substances when cleaning. This will cause damage.
5. Loosen the screw on the front grille. Open the grille to carefully clean the fan wheel (see picture).
---|---

Storage

• Clean the fan carefully as described above.
• For storage, carefully place the unit in the original carton or cover it to protect it from dust.
• Store it in a dry place.
• Never leave the power plug plugged in during storage.
• Do not wrap the power cord tightly around the device and do not subject the power cord to stress at the entry point to the device, as it will fiber or break.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.
This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>