KLARSTEIN 10031451 Stand Fan Instruction Manual

KLARSTEIN 10031451 Stand Fan

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Packaging materials (plastic bags, polystyrene, staples etc.) Must be kept out of the reach of children as they could be hazardous.
• Children over the age of 8 and persons with reduced physical, sensory or mental capabilities or those with a lack of experience and knowledge may only use the device if they are instructed on how to do so by a person responsible for their safety, or if they are supervised and understand the hazards associated with the use of the device. Children may not clean or carry out user maintenance without supervision.
• Do not leave the appliance unattended.
• Before connecting the appliance, check that the appliance rating corresponds to the mains rating.
• This appliance must only be used for the purpose for which it has been manufactured. As a stand fan. The manufacturer is not responsible for any damage caused by improper or incorrect use.
• The installation/assembly of the device will be made according to the indications of the manufacturer. A wrong procedure may cause damages to persons, animals or objects, for which the manufacturer cannot be considered responsible.
• Before cleaning or carrying out maintenance on the appliance, disconnect it from the electrical mains by removing the plug from the electrical outlet or by switching off the system switch.
• The appliance is not to be used if there are signs of damage. If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If the above is disregarded, the safety of the appliance may be compromised.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Do not power the device using multiple sockets.
• Do not use adapters and/or extension cable.
• The device must not be switched on using external timers and/or other remote control devices which are not specified in this manual.
• Do not use or store the device near heat sources (heaters, stoves).
• Do not dip the device in water or other liquids; in case the accidental fall in the water do not try to take it out, but first of all unplug immediately the power cable from the socket.
• If you use the device for the first time, make sure to remove any label or protective sheet which blocks its proper functioning.
• Do not pull the plug out of the socket by the cable, but hold it firmly by hand when pulling it off.
• Before plugging the plug into a wall outlet, make sure that the unit is switched off.
• Always unplug the power cable to avoid the overheating and avoid stretching it.
• Make sure that all air intakes and outlets are free and not covered so that the unit does not overheat.
• Avoid placing the power cable on abrasive or sharp surfaces or in positions where it can be damaged easily.
• Do not hang the fan on the wall or ceiling unless this type of installation is provided and explained in this manual.
• Place the device at a proper distance from the objects or surrounding walls making sure that its functioning will not cause accidental damages.
• Do not use the device near gas stoves or open flames in general.
• Do not use the device near curtains or textiles.
• Do not cover the device during functioning.
• Do not expose yourself for a long period to the air flow generated by the device because it can cause damage to the health.
• If the fan must be stored for a long period and is not used regularly, place the fan in its original packaging in a dry place.
• Always remember to unplug the power cable of the device if it is not used for a long period, before storing, cleaning or performing any maintenance operation.
• Do not use the appliance in the presence of potentially flammable or explosive liquids or gases.
• The appliance is not intended for commercial use, but only for household and similar environments. This includes kitchens in offices, farms, hotels, motels and Bed & Breakfasts. Do not use outdoors.

PRODUCT OVERVIEW

1. Front grille
2. Fan cap
3. Fan blade
4. Fastening nut
5. Rear grille
6. Motor spindle
7. Handle
8. Motor housing
9. Locking screw
10. Switch
11. Adjusting screw
12. Inner tube
13. Height adjustment collar
14. Outer tube
15. Stand
16. Screw

ASSEMBLING

Assembling the base
Loosen the screw (16) attached to the bottom of the outer tube (14). Slide the inner tube (12) into the outer tube and secure the tubes to the base with the screw. Place the motor housing (8) on the inner tube and secure it with the screws provided. Make sure the motor is firmly seated on the inner tube.
Attaching the fan and grille

1. Remove the nut from the front of the motor by turning it counterclockwise.
2. Place the rear grille on the front of the motor. The handle should be facing up so that the mounting pegs on the motor housing engage the holes in the grille.
3. Tighten the fastening nut clockwise. However, do not overtighten it.
4. Slide the fan blade onto the motor spindle and align the slot on the back of the blade with the spindle.
5. Tighten the fan cap counterclockwise.
6. Align the front grille with the rear grille so that the holes for screwing are on top of each other. Slide a bolt through the hole and tighten it with a nut. Do not tighten it completely yet.
7. Close the locking clips and make sure they are correctly seated on the edge of the grille. 8.
8. Then fully tighten the nut and bolt on the grille.

OPERATION

Control panel and remote control

C

| Speed indicator High (high) Medium (mid) Low (low)| ****

G

| ****

SWING button

D

| OFF button (OFF)| ****

H

| TIMER display 0.5h / 1h / 2h / 4h

Commissioning and Operation

1. Connect the device to a power outlet. The power indicator (A) turns on.
2. Switch on the unit by pressing the ON/SPEED key (F) on the control panel. The fan starts to run at low speed. The speed indicator (C) lights up.
3. To change the speed, press the ON/SPEED key (F) several times. The speed changes with each press of the key. The corresponding indicator (C) lights up.
4. To make the fan swing back and forth, press the SWING key (G). The SWING indicator light (B) turns on and the fan begins to oscillate back and forth. To stop the oscillation, press the SWING button (G) again.
5. The fan has a timer. After you turn on the unit, press the TIMER button (E) and the fan will run as long as you set it. To do this, press the TIMER button several times and the time will change with each press of the button. The indicator lights (H) will light up. After the set time has elapsed, the fan will automatically turn off. The timer can be set from 0.5-7.5 hours. The time results from the sum of the illuminated control lights (H).
6.  The air flow can be directed upwards or downwards by tilting the motor. Loosen the fixing screw (9) and adjust the motor so that it points in the desired direction. Tighten the screw again.
7. To switch off the fan, press the OFF key (D).
8. Always unplug the unit when not in use.

Note on the remote control
The buttons on the remote control have the same function as the buttons on the control panel. Make sure that batteries are inserted into the remote control the right way around. Do not mix battery types and always replace all batteries at the same time when changing batteries. Be sure to replace the batteries with batteries of the same type (2xAAA).

CLEANING AND CARE

• Always unplug the unit before moving or servicing.
• Do not immerse the power cord, plug and the whole unit into water or rinse under the tap.
• Do not use detergent, gasoline, benzene, thinner, or other solvents to clean the unit to avoid damage of the appliance.
• Unplug the unit and wait until the fan stop running before cleaning.
• Use a damp cloth to clean the surface of the fan.
• If the fan will not be used for a long time, store it in the cool, dry, safety place and far away from children. Do not store the appliance in hot place and under sunshine.
• It is recommended to clean the fan every month.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service. This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited Unit 6 Riverside Business Centre Brighton Road Shoreham- by-Sea BN43 6RE United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>