GLEN SA 4022 Platinum Plus MIXER GRINDER User Guide
- June 5, 2024
- GLEN
Table of Contents
- GLEN SA 4022 Platinum Plus MIXER GRINDER
- WARRANTEE
- PACKING LIST
- TECHNICAL DATA
- IDENTIFY YOUR MIXER GRINDER SA 4022 PLATINUM
- USING THE LIQUIDISER JAR
- TO CLEAN THE JAR
- USING THE GRINDER JAR/ CHUTNEY JAR
- FUNCTIONS
- FEW TIPS
- OVERLOAD PROTECTION
- SAFETY PRECAUTIONS
- INSTRUCTIONS
- WARNING
- BLENDER JAR WITH FRUIT FILTER
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
GLEN SA 4022 Platinum Plus MIXER GRINDER
WARRANTEE
This GLEN Mixer Grinder is fully warranted against any defect arising out of defective materials or faulty workmanship for a period of 2 years from the date of purchase. The motor is fully warranted against any manufacturing defect for a period of five years from the date of manufacturing (inscribed on the motor). Should any defect develop in this product, the customer should bring the product to the nearest authorised service centre, where the company undertakes to get the product repaired free of charge. This warranty is not valid if:
- The use and care instructions have not been followed.
- Defects are caused by accident, misuse, abuse, or commercial use.
- The repair work is carried out by persons not authorized by the company.
- Any modification or alteration of any nature is made in the product.
- Normal wear & tear of the product is not covered under the warranty
- The Bill/Cash memo and copy of the warranty card are not presented.
Under no circumstances, whether based on a limited warranty or otherwise shall the company be liable for incidental, special or consequential damages. Use of product indicates acceptance by you of the aforesaid terms and conditions.
PACKING LIST
SA 4022 PLATINUM
Basic Unit, Liquidiser Jar with Lid, Grinder Jar with Lid, Plastic Jar with
Lid, Chutney Jar with Lid, Whipping Blade, Spatula, User’s Guide.
SA 4022 PLATINUM PLUS
Basic Unit, Blender Jar with Lid, Liquidiser Jar with Lid, Grinder Jar with
Lid, Plastic Jar with Lid, Chutney Jar with Lid, Whipping Blade, Spatula,
Fruit Filter, User’s Guide.
TECHNICAL DATA
Rated Voltage | 230VAC50Hz |
---|---|
Input | 750W |
Rating | 30 minutes ( 3 minutes ‘ON’ 2 minutes ‘OFF’) |
Classification | Class I, Ordinary |
Insulation | Class H |
Motor | Universal Motor: 750 W |
No Load Speed: Maximum 18000 rpm approx.
Material|
(Housing of Basic Motor Unit)| High Quality ABS Plas tic / PPMF
(Liquidiser , Wet & Dry Grinder Jar)| Stainless Steel
(Lid for Liqui diser / Blender & Grinder Jar)| Polycarbonate
(Blades)| Stainless Steel (304)
Speed Control| Pulse, Low, Medium & High
Overload Protection| Hand reset type overload protector
Power Cord| Three Core (ISi Marked), 1.5 Meters (appx) With
6 Amp. 3 Pin Plug (ISi Marked)
Capacity|
Normal load in terms of recipe| Urad dal 100 gms in adequate quantity soaked
refer cl 2.4 of IS: 4250-1980| for 12 hrs.
Dry Grinding| 100ml
Liquidiser / Blender Jar| 1.50 litre
Carton Dimensions (mm)| 490 x 240 x 325 (W x D x H)
Weight| 5.00 Kg. (approx.) 4022 Platinum
5.50 Kg. (approx.) 4022 Platinum Plus
NOTE
- The mixer is not suitable for Egg whisking.
- Development is a continuous process of improvement, the specifications are subject to change without prior notice.
- The size of the Liquidiser/ Blender jar is 1.5 litres, Grinder jar 1.00 litre & Chutney jar 0.40 litre
IDENTIFY YOUR MIXER GRINDER SA 4022 PLATINUM
USING THE LIQUIDISER JAR
- Select the blade as per requirement viz. for whipping or blending. Fix the blade on the shaft, rotating clockwise with the help of the spatula. Ensure that the blade assembly rotates freely.
- Fix the jar onto the basic unit, by aligning the marking of the jar and main unit and rotating clockwise to lock the jar into position.
- Fill the ingredients, close the jar lid and hold with your hand.
- Operate the machine with the knob at the desired speed. (The Pulse switch can be used for additional froth in Lassi or Cold Coffee)
TO CLEAN THE JAR
- Pour a little liquid soap and water into the jar, close the lid and run it on position 1 for a few seconds. Pour out the soap solution and rinse with tap water.
- Remove the blade assembly using a spatula handle. Wipe the area along the blade with a wet cloth and then dry.
USING THE GRINDER JAR/ CHUTNEY JAR
- Fit the jar onto the basic unit, by aligning the marking of the jar and the main unit and rotating clockwise to lock the jar into position.
- Fill ingredients into the jar and close the lid hold the lid by hand. Turn the knob to the desired speed to start the operation.
- After grinding, remove the contents and wipe the jar with a dry cloth. For the Chutney Jar follow the instructions for the Liquidiser Jar except that the blade is fixed.
FUNCTIONS
Dry Grinding
Spices, coffee beans, rice, sugar, turmeric, wheat etc.
Mincing / Grating
Coconuts, carrots, radishes, onions, cabbages, dry fruits, meat etc.
Whipping
Lassi, mayonnaise.
Wet Grinding/ Liquidising/ Pureeing/ Blending
Dais, soups, juices, churning butter, pastes (onion, ginger, garlic, leafy,
vegetables).
FEW TIPS
For Thick Pastes: Fill the grinder jar upto blade level and add the required amount of water so that the blades don’t get jammed. For small quantities use the Chutney Jar. For Blending Liquids & Whipping : Do not Fill the liquidiser full capacity to avoid spillage. Keep space around the mixer. Hold the Lid by hand while in operation.
OVERLOAD PROTECTION
To protect the motor from burning, in case of overload, the appliance is fitted with an automatic overload protector under the base of the basic unit. If the motor stops it is an indication of excess load. Switch off the unit, take out excess material from the jars. Wait for 2/3 minutes and press the overload protection plunger. Then restart the unit.
Note: Overload protection plunger is to be pressed to restart only after 2/3 minutes.
SAFETY PRECAUTIONS
- While grinding always ensure that the blades are covered by the substance to be ground.
- Give a break of at least two minuteaftercontinuousgrindingof3 minutes.
- Do not allow children to handle the MG.
- Keep the machine away from direct heat and sunlight, at a suitable height on a flat surface for easy operation.
- Do not use the MG for ice crushing or grinding raw meat.
- Before running the machine ensure that the jars and lids are firmly placed and locked. Do not remove or replace jars when the motor is on.
- While operating run the machine in short cycles of 30-90 seconds as per requirement, do not run it for a long duration.
- Wide voltage fluctuations during operation may affect the quality of grinding, but the motor may still be safe. It is safer to use an MG only when you get steadier voltage in your area.
- While dry grinding the jar may get heated up due to friction. Don’t worry it has nothing to do with the motor.
- Donotoverloadthemachine.
- In case of smoke or smell put off the machine.
- Read the instructions carefully & be familiar with the product.
INSTRUCTIONS
- If there is any manufacturing/ functional defect in your mixer-grinder, take it to the authorised dealer along with your warranty card.
- or long trouble-free smooth performance, oil the shaft with edible oil every six months.
- Rotate the motor shaft (housed in the basic unit) by hand through the coupler and make sure that it’s free in movement when used after a long period.
- Before fixing the jar in the basic unit, rotate the jar shaft with your hand to make sure that it works smoothly.
- Switch on the machine at speed 1 for a few seconds to ensure that the motor works properly or check with incher switch.
- In case of dry grinding, stop the machine after one minute, open the lid & check the fineness of the powder. If need the scrape down the material and carry out one more cycle.
- While grinding hard substances like turmeric (Haldi), please ensure that it is dry & broken in small pcsofapprox 1 cm.
- The ingredients should be filled in the jar up to blade level as a minimum. For larger quantities, the jar should not be filled with more than half of its capacity.
WARNING
- Do not place any thin paper or cloth under the basic unit. It may get sucked up and clocked the ventilation holes and even burn our motor.
- Do not clean the filter mesh by use of any steel object, knife etc. As it may get damaged.
- Do not immerse the basic unit, plug or cord in water or in other liquids to protect yourself against electrical hazards.
- Do not allow children or any other person, not conversant with the mixer, to handle your appliance.
- Do not let the power cord hang over the edge of the table.
- Do not run an empty jar and also do not run the motor with a heavier load more than that is specified in the user’s booklet.
- o not operate till the lid/ dome is in position on the grinder/ blender jar.
- Do not leave the mixer unattended while in operation.
- Do not run the mixer for more than 30 minutes at a stretch. Give the unattended machine 15 minutes’ rest before starting it again.
- Do not fix or remove the blender/ grinder jar while the motor is running.
- Do not use a mixer when the base, plug or cord is in contact with water as this can cause electrical hazards.
- Do not use the mixer outdoors or on wet surfaces.
- Do not place the mixer on or near a hot surface.
- Do not attempt any repairs to the mixer yourself or allow anyone else to do so except for the authorised dealer.
BLENDER JAR WITH FRUIT FILTER
USING THE FRUIT FILTER
Insert the fruit filter into the blender jar and rotate it slightly so that it settles down and the grooves get locked with the slugs on the Plastic jar wall. Place the lid on the jar (Drainage windows of lid towards jar spout) and rotate it anti-clockwise to lock. Place the assembly onto the mixer grinder and rotate clockwise to lock it into position.
Cut small pieces of fruits (like watermelon, tomato etc.) to be juiced. Remove the cap on the lid by rotating anticlockwise. Run the mixer Grinder & put the cut pieces of fruit etc from centre portion of lid. You can continue adding more fruit pieces from the centre opening in the lid as they are juiced. The juice is sieved out through the filter and the pulp/seeds get accumulated inside the filter. Once the juicing is over, replace the cap. Remove the jar assembly from the mixer and pour out the contents from the jar by tilting.