KLARSTEIN 10033350 Ice Cube Maker Instruction Manual

KLARSTEIN 10033350 Ice Cube Maker

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Check that the mains voltage corresponds to the rating of the appliance before operating.
• Use handles or knobs when moving. Place on a flat stable surface for use. Do not use outdoors.
• Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
• Unplug from socket outlet when not in use.
• To protect against electric shock, do not immerse cord or plug in water or any other liquid.
• The use of accessory attachments not recommended by the appliance manufacturer, may cause injury.
• Do not locate this appliance immediately below a socket outlet.
• Do not allow cord to overhang the counter top where it can be easily pulled by children.
• Do not use this appliance for anything else other than its intended use.
• Do not overfill as this may cause a hazard. Ensure lid is closed when in operation
•  To remove plug from outlet, do not pull on supply cord. Grasp plug firmly and pull to remove.
• No liability can be accepted for any damage caused by non compliance with these instructions or any other improper use or mishandling. This appliance is for household use only
•  This appliance is not intended to be operated by means of an external timer or separate remote control system.
•  This appliance is not intended to be immersed in water.
•  If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
•  Please according to local regulations regarding disposal of the appliance for its flammable blowing gas.
•  Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• Fill with potable water only.
•  This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.

This appliance contains the coolant isobutane (R600a),a natural gas which is environmentally friendly. Although it is flammable, it does not damage the ozone layer and does not increase the greenhouse effect.

The use of this coolant has,however,led to a slight increase in the noise level of the appliance. In addition to the noise of the compressor,you might be able to hear the coolant flowing around the system. This is unavoidable,and does not have any adverse effect on the performance of the appliance. Care must be taken during the transportation and setting up of the appliance that no parts of the cooling system are damaged. Leaking coolant can damage the eyes.

WARNING
Danger from fi re/fl ammable materials. Please observe the local regulations for the disposal of units with fl ammable refrigerants and gases.

• Keep ventilation openings in the unit housing free of obstacles.
• Do not damage the refrigerant circuit.
• Do not use any mechanical devices or other means to accelerate the defrosting process or the ice recovery process.
• Do not use other types of electrical appliances inside the ice cube machine.

Special Notes

•  When positioning the unit, make sure that the power cord is not pinched or damaged.
•  Make sure that there are no multiple sockets or power supplies on the back of the unit.

To avoid contamination of food, please follow the instructions below:

• Regularly clean surfaces that may come into contact with food. Clean the water drain regularly.
• If the appliance contains a water tank, clean it if it has not been used for 48 hours. Rinse the tank if no water has been removed for 5 days.

WARNING
When using, servicing and disposing of the unit, pay attention to the left symbol on the rear of the unit or on the compressor. This symbol warns of possible fi res. There are fl ammable substances in the refrigerant lines and in the compressor. Keep the appliance away from sources of fi re during use, maintenance and disposal.

PRODUCT OVERVIEW AND KEYS

OPERATION

Unpacking your ice maker

1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is included. If any parts are missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it
3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e.: stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that there is at least 6 inches of space between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant fl uid to settle before plugging ice maker in.
5. The appliance must be positioned so that the plug is accessible.

Note: Fill with potable water only.

Connecting your ice maker

CAUTION
Risk of injury! Improper use of the earthed mains plug may result in electric shock. If the power cord is damaged, contact your service representative.

1. This unit should be properly grounded for your safety. The power cord of this appliance is equipped with a grounding plug which mates with standard grounding wall outlets to minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounding wall outlet. Do not under any circumstances, damage the grounding means of the plug under any circumstances. Any questions concerning power and/or grounding should be directed toward a certifi ed electrician.
3. This appliance requires a standard 220-240 Volt, 50 Hz electrical outlet with good grounding means.

Using your ice maker

1

| Remove the cover of the water reservoir and pour potable water into water reservoir.

•        Be sure to keep water level below the max. level with FULL. mark displayed in following picture

•        Then move back the cover at once to avoid foreign matter enter.

---|---

Water reservoir cover

Note: Do not pour the water into the internal water tank located underneath the ice basket. This tank is not big enough and will effect the ice making performance.

2

| Plug on the main power supply plug. Then press “ON/OFF” button on the control panel to begin the ice making cycle.
Note: After you plugging on but not turn on the unit through the “ON/ OFF” button, the green power indicator will always be on for 2 seconds, then flash for 3 seconds. But after you turn on the unit by pressing the “ON/OFF” button, the green power indicator will keep on lighting.

3

| The ice making cycle lasts about 15 to 20 minutes, depending on the

ambient temperature.

•        For the first time, according to the initial water temperature, ice-

making last time will be a little longer.

•        In the extreme hot room temperature, ice-making time maybe vary a

lot, but it will not exceed 40 minutes.

---|---
Note: After plugging on the unit, press “ON/OFF” button for more than 5 seconds, then release to start the unit, the unit will add 3 minutes more to each ic-making cycle automatically to thicken the ice cube. So if you desire to thicken your ice-cube, please turn off you unit first, then press “ON/OFF” button again for more than 5 seconds to turn on the unit again.

4

| While the ice-maker is on, verify the water level of the internal tank located underneath the ice basket periodically.

•        If there is no enough water to last ice-making cycle, the unit will automatically let the water flow from the big water reservoir downward to the internal tank to continue the ice-making process.

•        If both of the internal water tank and big water reservoir have no enough water,, the ice maker will stop automatically, and the “ REFILL

WATER” indicator will be on.

Note: Check to be sure that both of water filter located at bottom of big water reservoir and internal water tank are not blocked by the dirty substance or some foreign matter.
•        Second to fill water up to big water reservoir to the max. water level

mark.

•        After shipping or moving the unit, better to allow the refrigerant

liquid inside the compressor at least 3 minutes to settle before

restarting.

5| •        The ice maker automatically stops working when the ice basket is full

and the “REMOVE ICE” indicator will be on.

6

| •        Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If unit isn’t in use for a long time, drain all water left in the water tank and water reservoir.

CLEANING AND CARE

1. Always unplug the ice maker before servicing.
2. Take out the ice basket.
3. Clean the interior with diluted detergent, warm water and a soft cloth.
4. Then use the water to rinse the inside parts, and drain out the water from the draining port by unplugging the drain cap on the back.
5. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm water.
6. Dry the interior and exterior with a soft cloth.
7. When the machine is not in use for a long time, open the water drain cap to drain water completely out from the water reservoir.

Important notes on cleaning

•  After using your ice maker for a long time, we also suggest you should clean your unit. Especially to the water separator pipe and the wate filters, you must clean them periodically.

• If the water separator pipe is blocked and there is no water flowing down when you listen the compressor and the water pump inside are still working, please turn off the unit first and disassemble this pipe down, and clean it.

• Clean the each hole on the pipe wall displayed in following picture. After cleaning, install back the water separator pipe and be sure the right terminal of the pipe connect to the silicone pipe well and as original.

• For both of the water tank and the big water reservoir, clean them with diluted detergent, warm water and a soft cloth. Then use the water to rinse the inside, and drain out the water from the draining port by unplugging the drain cap on the back. It will help you keep the unit and ice-cube hygienicly, and also make the unit work normally.

How to drain out the water
Because the water in the big water reservoir is stop to drain port by the water valave, if you want to drain away all the water, please plug on the unit and but don’t start the unit, then remove the drain port cap at the back. Wait some minutes, all of the water will flow out.

TROUBLESHOOTING

water from the top big water reservoir up to MAX. mark, then press “ON/OFF” button again to restart the unit.
“REMOVE ICE” indicator

is on.

| There is too much ice.| Remove ice from ice basket.
The big reservoir full of wa-ter, but “REFILL WATER” indi-cator is always on.| The water is distillation water, it is too pure.| Chang the water to nomal potable water or mineral water.
The water filer at bottom

of the water reservoir is blocked. And water

can’t enter into the lower

water tank.

| Clean the water filter.
No water flow out from the water separator pipe.| The hole on the wall of the wa-ter separator is blocked.| Use slim wire to prick each hole, till the water can flow out easily.
Problem| Possible cause| Suggested solution
---|---|---
Ice cube is too weak and thin.| The ambient is too hot.| Turn off you unit first, then press “ON/OFF” button again for more than 5 seconds to turn on the unit again. It will lengthen each ice- making cycle time.
Ice making cycle is normal but no ice is made.| Ambient temperature or water temperature in inner tank is too high.| Please run the ice maker below 32℃ and pour colder water into tank.
Refrigerant liquid leakage.| Verify by a qualified

technician.

Pipe in the cooling system is blocked.| Verify by a qualified

technician.

No water in the unit, but the “REFILL WATER” indicator is not on, unit can not make ice cube.| The water is not enough pure. Maybe you have used the salt water or others.| Chang to the normal potable water. The salt water is prohibited, it will damage your unit.
The wall of the lower tank underneath the ice basket is too dirty.| Clean this water tank.

MANUFACTURER & IMPORTER (UK)

Manufacturer :
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>