Zoroufy Classic Tapestry Wall Hanger Collection Instruction Manual
- June 5, 2024
- Zoroufy
Table of Contents
Zoroufy Classic Tapestry Wall Hanger Collection
Installation Instructions
Specifications
Sets 72″ & Under
- Remove screws from finials. Align the hole on the bottom of the finial with the outside hole for both left and right end brackets. Insert and attach screw so finial and bracket are tightly connected. Repeat for both end brackets.
- Place left end bracket on wall at desired location to be attached. Position bracket holes on bottom, as shown in diagram above.
- Install screws through bracket holes into wall.
- Slide rod into the installed end bracket. Take the center bracket and slide over rod. Attach center bracket to wall in center of rod.
- Slide right end bracket over right end of rod and attach to wall with screws.
- Attach clips by sliding over rod.
Note: Wall anchors must be used if screws are not installed into a wall stud.
Sets Over 72″
- Remove screws from finials. Align the hole on the bottom of the finial with the outside hole for both left and right end brackets. Insert and attach screw so finial and bracket are tightly connected. Repeat for both end brackets.
- Place left end bracket on wall at desired location to be attached. Position bracket holes on bottom, as shown in diagram above.
- Install screws through bracket holes into wall.
- Slide rod into the installed end bracket. Take the center bracket and slide over rod. Attach center bracket to wall in center of rod.
- Place double-wide center support bracket on end of rod. Insert the rod through half of the bracket. Secure rod by tightening the small set screw on face of bracket. Repeat with second rod.
- Take the last center bracket and slide over rod. Attach center bracket to wall in center of rod.
- Slide right end bracket over right end of rod and attach to wall with screws.
- Attach clips by sliding over rod.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>