Zoroufy 2023 Regency Wall Hanger Collection Installation Guide
- June 13, 2024
- Zoroufy
Table of Contents
Zoroufy 2023 Regency Wall Hanger Collection
Product Information
This product is a Finial, specifically the Pineapple Ball Urn model. It is a decorative accessory used for hanging rugs, tapestries, or quilts on the wall. The finial is made of lacquer-coated material to resist tarnishing and maintain its appearance. It comes with a rod, end support brackets, center support bracket(s), clips, and a disc for securing the rug or tapestry.
Product Usage Instructions
- Attach the finial by inserting the rod into the finial base and tightening the small screw.
- Slide the first end support bracket onto the rod.
- Hold the rod in the desired position against the wall and mark the position of the holes in the attached end support bracket.
- While supporting the opposite side, install the attached end support bracket.
- Slide the remaining support brackets onto the rod and locate the desired position by leveling the rod. Install the second-end support bracket on the opposite end.
- Install the center support bracket(s) evenly between the end support brackets.
- Attach the clips to the rug, tapestry, or quilt and secure them in place by tightening the disc over the rod.
- If bracket screws are not installed into a stud, wall anchors must be used to ensure stability.
Note: It is important to periodically check and tighten all screws and hardware to maintain proper functionality. To clean the finial, simply wipe it with a soft dry cloth. Avoid using brass cleaner or other abrasives as they may damage the lacquer coating.
SPECIFICATIONS
FINIAL LENGTH
Pineapple 2 /½”
Ball 2”
Urn 2 /¼”
ROD GAUGE .031”
ROD DIAMETER /½”
Zoroufy® Regency rods slide into each finial approximately ¾”. Finials attach to the rod.
| Finial measurements vary by style.
INSTALLATION INSTRUCTIONS
1. Attach the finial by inserting the rod into the finial base and tightening
the small skew.
2. Slide the first end support bracket onto the rod. Hold the rod in the
desired position against the wall and mark the position of the holes in the
attached end support bracket.
3. While supporting the opposite side, install the attached end support
bracket.
4. Slide the remaining support brackets onto the rod and locate the desired
position by leveling the rod. Install the second-end support bracket on the
opposite end.
5. Install the center support bracket(s) evenly between the end support
brackets.
6. Attach the clips to the rug, tapestry, or quilt and secure in place by
tightening the disc. Place the clips over the rod. Wall anchors must be used
if bracket screws are not installed into a stud.
ALL PARTS ARE LACQUER-COATED TO RESIST TARNISHING. DO NOT USE BRASS CLEANER OR OTHER ABRASIVES. TO CLEAN, SIMPLY WIPE WITH A SOFT DRY CLOTH. PERIODICALLY CHECK AND TIGHTEN ALL SCREWS AND HARDWARE.
CONTACT
- 2140 W.
- GREENVIEW DR. SUITE 5, MIDDLETON,
- WI 53562-0345
- 800-762-1525
- info@zoroufy.com.
- www.zoroufy.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>