Zoroufy Regency Wall Hanger Instruction Manual

June 12, 2024
Zoroufy

Regency™ Wall Hanger
Patent #5,318,174
Installation Instructions Zoroufy Regency Wall Hanger
1

Regency Wall Hanger

Zoroufy Regency Wall HangerFinial measurements vary by style. Please see chart to left
ALL PARTS ARE LACQUER COATED TO RESIST TARNISHING. DO NOT USE BRASS CLEANER OR OTHER ABRASIVES. TO CLEAN, SIMPLY WIPE WITH A SOFT DRY CLOTH.
PERIODICALLY CHECK AND TIGHTEN ALL SCREWS AND HARDWARE

Specifications

Finial Length
Pineapple 2 ½”
Ball 2”
Urn 2 ¼”’
Rod Gauge .031”
Rod Diameter ½”

Zoroufy Regency Wall Hanger - parts

  1. Attach finial to rod by inserting rod into the finial base and tightening the small set screw. If using a sleeve, See step 6 and then continue with steps 3-5 in order.
  2. Slide support bracket onto the rod and attach remaining finial to rod by tightening the small set screw previously attached to the finial.
  1. Locate desired position of support brackets on the wall, making sure the rod is level. A support bracket should be positioned near both ends of the rod and the remaining support bracket(s) should be in the center or evenly spaced on the rod if there is more than one center support.
  1. Mark the installation holes of support brackets. Install the support brackets using screws provided. You must use wall anchors (not included) suitable for your wall material, if screws are not screwed into a stud.
  2. Attach clips to rug or tapestry and hang by placing over the rod. If clips are not being used and a sleeve is, mark where the brackets are and cut a small slit, vertically allowing the bracket to show through. Place rug or tapestry on rod and slide carefully through brackets.

2140 W. GREENVIEW
DR. SUITE 5, MIDDLETON
WI 53562-0345
800-762-1525
[email protected]
www.zoroufy.com

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Zoroufy User Manuals

Related Manuals