GLACIER BAY BY569 High Efficiency Water Dispenser User Guide
- June 5, 2024
- GLACIER BAY
Table of Contents
GLACIER BAY BY569 High Efficiency Water Dispenser
Care and Cleaning
Cleaning The Outside Of The Water Dispenser
Ensure the unit is unplugged. Wipe the outside of the dispenser with water. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry surfaces.
Cleaning The Drip Tray
To remove, lift the drip tray up. Drain and clean. The drip tray should be
emptied and cleaned regularly to avoid spotting and any mineral deposits.
Clean with water or water dispenser cleaner. Then wash, rinse, and dry
thoroughly. Never clean the drip tray in the dishwasher. The tray is not
dishwasher safe.
Cleaning The Condenser
Vacuum or sweep away the dust from the condenser coils at the back of the dispenser. For best results, you can purchase a brush designed specifically for this purpose from your local appliance store. This will improve cooling and efficiency.
Draining The Reservoirs
- Ensure the unit is unplugged. Drain the reservoirs before and after cleaning.
- Remove the water bottle.
- Place a cup below the spout.
- Press each water button.
- Dispense hot water from the spout until water no longer comes out.
- Dispense cold water from the spout until water no longer comes out.
- Release the water buttons.
- Place a bucket beneath the drain cap on the back of the dispenser and open the drain cap, being cautious of the hot water.
- Let the water flow into the bucket.
- Close the drain cap.
- Install a new water bottle.
Ensure the unit is unplugged. Drain the reservoirs before and after cleaning.
- Remove the water bottle.
- Place a cup below the spout.
- Press each water button.
- Dispense hot water from the spout until water no longer comes out.
- Dispense cold water from the spout until water no longer comes out.
- Release the water buttons.
- Place a bucket beneath the drain cap on the back of the dispenser and open the drain cap, being cautious of the hot water.
- Let the water flow into the bucket.
- Close the drain cap.
- Install a new water bottle.
Going Away On Vacation
When not using the dispenser for long periods of time or when going on vacation, unplug the dispenser and drain the reservoirs. Follow Initial Product Cleaning Procedures upon return and startup of the dispenser
Frequently Asked Questions
- Q: Why do I get a plastic taste from my dispenser?
- A: As with most nevw appliances such as coffee makers and kettles, there is often a plastic taste upon initial start-up of the unit. To remove this taste, simply follow the cleaning instructions outlined in Cleaning the Inside of the Dispenser.
- Q: What is the spike that goes into the bottle?
- A: Glacier Bay® water dispensers feature a “piercing valve” as part of the bottle support collar, providing added convenience for water bottle installation. Depending on the water bottle supplier, some water bottles incorporate a self-piercing membrane in the bottle cap for this specific purpose (ask your water bottle supplier if your water bottle incorporates this feature). If your water bottle does not incorporate this feature, the entire bottle cap must then be removed to eliminate possible damage to the piercing valve.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>