KERNOWO 118 LED Outdoor Solar Light User Manual
- June 14, 2024
- KERNOWO
Table of Contents
KERNOWO 118 LED Outdoor Solar Light
Installation
- Press the button on the back and select the mode you want.
- Then choose a place that can get enough sunshine to install this wall light. The longer it gets sunshine, the longer the lights can last.
- Fix The Base (pie 1): Punch two holes on the wall with a drill bit, insert the attached expansion pillar-hinge into the holes, and drill the screws through the base into the wall.
- Choose The Angle, Install The Light (Pie 2): Attach the adjustable pivot arm to the base, adjust to the desired angle, then tighten it through the knob screw.
Operation Guide
- No light during the day in any mode, bright at night. During the day test, please cover the solar panel and keep it in a dark environment, otherwise the light will not be on.
- The default mode of the product is OFF mode. Click the black button on the back of the light panel, each press the black button will change one mode. Mode set in the cycle (Mode1-Mode2-Mode3-off).
Lighting Modes
Mode1: Strong Light Sensor Mode (Recommended)
The product charges in the day auto turn on a bright light in darkness or at
night when motion is detected and lasts about 20 seconds then the light will
go off when there is no motion.
Mode2: Dim Light Sensor Mode
The product charges in the day and auto turns on a dim light in darkness or at
night when no motion is detected; it will turn to a bright light when motion
is detected and last about 20 seconds then it will turn to dim light again
when there is no motion.
Warm Tips
-
It is recommended to turn off the light and charge in the sun for 1-2 days before first use, otherwise, insufficient power will affect the use time.
-
Place the solar panel in a sunny place with no obstacles, with the front of the solar panel facing the sunniest angle.
-
Please avoid direct light on the solar panel at night. Otherwise, the light sensor judges that it is daytime, and the light will not light up.
-
Whether the LED solar sensor wall light can produce the best lighting effect or not depends on the sunshine intensity, geographical- cal location, weather conditions, seasons, and other conditions.
Two Ways to Change Modes: -
Click the black button on the back of the light panel, each press of the black button will change one mode. Mode set in the cycle(Mode1 Mode2-Mode3-Off).
-
Change mode with Remote control. But you must active the lights by clicking the button on the back of the lights.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>