GLACIER BAY GB30P2-PG Vanity Combo User Guide
- June 4, 2024
- GLACIER BAY
Table of Contents
GLACIER BAY GB30P2-PG Vanity Combo
Safety Information
To ensure that your installation goes smoothly, please read these instructions
thoroughly prior to starting.
DANGER: Failure to follow warnings and cautions could result in serious
injury. Do not exceed the maximum load capacity. Do not stand on cabinet. Use
cabinet on level ground.
WARNING: Base cabinet supports a maximum weight of 200 lbs. Exceeding
maximum weight limit will compromise the integrity of the cabinet structure
and could cause the cabinet to fail.
CAUTION: Do not hang from the cabinet.
Pre-Installation
Tools Required
Base Levelers Included
Base levelers are included in a plastic bag within vanity.
Installation
-
Adjustable Height Levelers (Legs) (If Applicable)
- Make sure the base of the vanity is leveled by laying a level (not included) across the top. If adjustment is needed use base levelers located in a plastic bag within vanity.
- To lower the cabinet turn levelers clock wise or to rise the cabinet turn levelers counter clock wise.
- Adjust until level across the top is leveled.
-
Shelf Installation (If Applicable)
- Before installing the cabinet, please place included shelf through the back of the cabinet as shown on picture.
-
Vanity Installation
- Fasten the vanity cabinet to the wall with 2 screws (not included) into wall studs through the back top rail or use toggle bolts if necessary.
- Decorative hardware are attached to the inside of the vanity.
Re-attach so the decorative hardware are visible from the outside of the doors.
-
Full Extension Drawer Glide Removal (If Applicable)
-
Open the drawer as far as possible.
-
Identify the plastic spring clips located in both slides.
-
At the same time, press the right slide spring clip downward and the left slide spring clip upward (Fig.#1 & Fig.#2).
-
Once both spring clips are held in the indicated position, pull the drawer straight out.
Epoxy Drawer Glide Removal (If Applicable) Fig.#3 -
Open the drawer as far as possible.
-
Lift the front part of the drawer to reach a 30º angle position.
-
Pull the drawer straight out.
-
-
Vanity Top Installation
- Set the vanity top on top of the vanity base, checking the location of the p-trap and drain.
- Remove the top and install the faucet per manufacturer’s installation instructions.
- Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten the pop-up drain. Over tightening may cause cracks on the marble top.
- Apply a thin bead of silicone compound around the vanity base and set the vanity top carefully in place. Remove any excess silicone compound with a wet rag.
- Install the faucet, water lines and P-trap according to manufacturer’s installation instructions.
-
Full Extension Drawer Glide Installation (If Applicable)
-
Maintaining both slides completely closed, move the component of slides with ball bearings to the front of the slides.
-
Carefully line up the slides of the drawer box with the slides in the vanity and close the drawer all the way back.
-
Open the drawer completely to ensure it is properly installed.
Epoxy Drawer Glide Installation (If Applicable) -
In a 30º angle position, introduce the drawer in the vanity making sure the drawer slide wheels are above the vanity slide wheels.
-
Close the drawer completely and to ensure it has been properly installed.
-
-
Hinge/Door Adjustment (If Applicable
The door alignment was set in the factory, but it could have shifted during transit. If adjustment is needed, follow the instructions provided in the adjacent chart.
-
Hinge/Door Adjustment (If Applicable)
- Remove decorative hardware from the drawer front.
- Hold drawer front in place and slightly loosen both alignment screws.
- Move the drawer front left, right, up or down to desired position for alignment.
- While holding the drawer front in place, tighten the alignment screws securely.
- Install the decorative hardware to the outside of the drawer front.
-
Mirror Installation (If Included)
- Determine the desired location of the mirror. Use appropriate screws or wall anchors (not included) to hang mirror.
- Be sure the hanging hardware is rated to handle the weight of the mirror. The mirror weight is approximately 20 lbs.
Care and Cleaning
Vanity
- To clean surface of doors or cabinet, use non-abrasive cleaners and or cleaning agents that do not contain solvents.
Vanity Top
- Your vanity top will remain in its original state if you maintain and clean it properly. Clean the surface with a glass cleaner or other household cleansers that are non-abrasive. Using abrasive cleansers will damage the surface.
Mirror
- Use non-abrasive cleansers only.
For California Customers Only
WARNING: DRILLING, SAWING, SANDING OR MACHINING WOOD PRODUCTS CAN EXPOSE
YOU TO WOOD DUST, A SUBSTANCE KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER. AVOID INHALING WOOD DUST OR USE A DUST MASK OR OTHER SAFEGUARDS FOR
PERSONAL PROTECTION.
For more information go to www.P65Warnings.ca.gov/wood.
Important Health Notice For Minnesota Residents Only
Some of the building materials used in this home (or these building materials) emit formaldehyde, eye, nose, and throat irritation, headache, nausea and a variety of asthma-like symptoms, incluiding shortness of breath, have been reported as a result of formaldehyde exposure. Elderly persons and young children, as well as anyone with a history of asthma, allergies, or lung problems, may be at greater risk. Research is continuing on the possible long- term effects of exposure to formaldehyde.
Reduced ventilation may allow formaldehyde and other contaminants to accumulate in the indoor air high indoor temperatures and humidity raise formaldehyde levels. When a home is to be located in areas subject to extreme summer temperatures, an air-conditioning system can be used to control indoor temperature levels. Other means of controlled mechanical ventilation can be used to reduce levels of formaldehyde and other indoor air contaminants.
If you have any questions regarding the health effects of formaldehyde, consult your doctor or local health department.
Warranty
LIMITED LIFETIME WARRANTY APPLICABLE TO USA
This product is warranted under normal use and service, to be free from
defects in material and workmanship for the life of the product from the date
purchased. During this warranty period, Seller will, free of charge, repair or
replace the Product at its sole discretion. Proof of purchase, photo and the
nature of the problem is required. Our warranty does not cover damage or
failure caused by abuse, misuse, abnormal usage, faulty installation, improper
maintenance or any repair other than those by Seller. There are no obligations
or liabilities on the part of Seller for consequential damage arising out of
or in connection with the use or performance of the product or any indirect
damages included, but not limited to labor charges for installation or
removal. This warranty gives you specific legal rights, and you may also have
other rights that may vary from state to state. Further information regarding
this warranty may be obtained without charge by contacting Customer Service.
If any parts are missing or damaged, please send a copy of your receipt along
with your inquiry to
customercareWC@masterbrand.com.
QUESTIONS
Questions, problems, missing parts?
Before returning to the store, please call Customer Service
Please contact
(USA) 1-800-235-7747
further assistance.
HOMEDEPOT.COM/GLACIERBAY
Importado por: WOOD CRAFTERS MEXICO HOLDING S. DE R.L. DE C.V., Carretera a
Matamoros KM. 114, 8-A, Col. La Paz, Rio Bravo, Tamaulipas, 88990, RFC:
WCM080125835 | Tel. 899-932-0170
Retain this manual for future use. Conserve este manual para futuro uso.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>