LOCKMASTER LM173 Wireless Push Button User Manual
- June 6, 2024
- LOCKMASTER
Table of Contents
LM173 Wireless Push Button
User Manual
Thank you for purchasing the wireless push button remote control (LM173). It can be mounted not only on walls in the room but also in the car or any other place for user convenience. Read the manual carefully and completely before you permanently mount the push button.
Installation
There are 2 parts of the push button, one is the remote key and another is the
holder. You should take the remote key out before the installation.
You can detach the holder from the push-button according to Fig.1.
There are 2 methods to install the push button according to your needs.
One is permanently mounting to the wall (Fig.2) and another is installed to
the post for portable use (Fig.3).
Program the push button to the control board
Press and release the learn button on the control board, the LED will display “Ln” for LM902/LM901 (REM LED light will be on for DSR/C 600/1000, SFG/SCG 17/18/20/21/50), then press the remote key of the push-button twice in 2 seconds, the LED will flash “Ln” for 4 seconds then back to “- -” for LM902/LM901 (REM LED light will flash for 4 seconds and then off for DSR/C 600/1000, SFG/SCG 17/18/20/21/50). Now the push button has been programmed successfully.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
©2012-2014 LockMaster All Rights Reserved
Documents / Resources
|
LOCKMASTER LM173 Wireless Push
Button
[pdf] User Manual
LM173, 2A5SN-LM173, 2A5SNLM173, LM173 Wireless Push Button, Wireless Push
Button
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>