GLACIER BAY DR12P2-PG 12 Inch W x 15 Inch D Bath Vanity in Pearl Gray User Guide
- October 30, 2023
- GLACIER BAY
Table of Contents
USE AND CARE GUIDE
VANITY COMBO
Questions, problems, missing parts? Before returning to the store, please call
Customer Service
(USA) 1-800-235-7747
(MX) 800- 570-0319
HOMEDEPOT.COM/GLACIERBAY
Safety Information
To ensure that your installation goes smoothly, please read these instructions
thoroughly prior to starting.
DANGER: Failure to follow warnings and cautions could result in serious
injury. Do not exceed the maximum load capacity. Do not stand on cabinet. Use
cabinet on level ground.
WARNING: Base cabinet supports a maximum weight of 200 lbs. Exceeding
maximum weight limit will compromise the integrity of the cabinet structure
and could cause the cabinet to fail.
CAUTION: Do not hang from the cabinet.
For California Customers Only
Warning: This product can expose you to chemicals including wood dust
which is known to State of California to cause cancer. For more information,
go to www.P65warnings.ca.gov
Warning: Drilling, sawing, sanding or machining wood products can expose
you to wood dust, a substance known to the State of California to cause
cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for
personal protection. For more information go to
www.P65warnings.Ca.Gov/wood
For California Customers Only
Some of the building materials used in this home (or these building
materials) emit formaldehyde, eye, nose, and throat irritation, headache,
nausea and a variety of asthma-like symptoms, including shortness of breath,
have been reported as a result of formaldehyde exposure. Elderly persons and
young children, as well as anyone with a history of asthma, allergies, or lung
problems, may be at greater risk. Research is continuing on the possible long-
term effects of exposure to formaldehyde.
Reduced ventilation may allow formaldehyde and other contaminants to
accumulate in the indoor air high indoor temperatures and humidity raise
formaldehyde levels. When a home is to be located in areas subject to extreme
summer temperatures, an air-conditioning system can be used to control indoor
temperature levels. Other means of controlled mechanical ventilation can be
used to reduce levels of formaldehyde and other indoor air contaminants.
If you have any questions regarding the health effects of formaldehyde,
consult your doctor or local health department.
Pre-Installation
TOOLS REQUIRED
Installation
-
To Connect To Other Cabinets
STOP: If you are building a configuration with other cabinets, determine which side will be connected to another cabinet. Complete drilling through the two blind holes.
• Drill through the blind holes located on the interior side of
the cabinet, using the 6 mm drill bit.
– For 24″ cabinets only, it is necessary to open both doors to drill.
– For 14″ cabinets, it is necessary to remove the upper and bottom drawer to drill (See Drawer Removal).
– For 30″ cabinets, it will be necessary to open both doors and remove the drawer (See Drawer Removal)
• Insert the installation screws (included) in the holes and tighten them using two Phillips screwdrivers.
• Replace the drawers that you removed from the cabinet, if it applies (See Drawer Installation)
• Place the cabinets in the desired location and level them. -
Vanity Installation
• Once the vanity is leveled, fasten the vanity cabinet to the wall with 2 screws (not included) into wall studs through the back top rail or use toggle bolts if necessary.
• Decorative hardware is attached to the inside of the vanity. Re-attach so the decorative hardware is visible from the outside of the doors. -
Drawer Removal (If Needed)
In order to install vanity top it may require the removal of vanity drawers. If so, follow these steps.
• Open the drawer as far as possible.
• Identify the plastic spring clips located in both slides.
• At the same time, press the right slide spring clip downward and the left slide spring clip upward. (Fig.#1 & Fig.#2).
• Once both spring clips are held in the indicated position, pull the drawer straight out.
Epoxy
Drawer Glide Removal (If Applicable) Fig.#3
• Open the drawer as far as possible.
• Lift the front part of the drawer to reach a 30º angle position.
• Pull the drawer straight out.
-
Vanity Top Installation
• Set the vanity top on top of the vanity base, checking the location of the p-trap and drain.
• Remove the top and install the faucet per manufacturer’s installation instructions.
• Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten the pop-up drain. Over tightening may cause cracks on the marble top.
• Apply a thin bead of silicone compound around the vanity base and set the vanity top carefully in place. Remove any excess silicone compound with a wet rag.
• Install the faucet, water lines and P-trap according to manufacturer’s installation instructions.
-
Drawer Installation
If removal of vanity drawers was necessary then follow these steps to reinstall.
• Maintaining both slides completely closed, move the component of slides with ball bearings to the front of the slides.
• Carefully line up the slides of the drawer box with the slides in the vanity and close the drawer all the way back.
• Open the drawer completely to ensure it is properly installed.
Epoxy Drawer Glide Installation (If Applicable)
• In a 30º angle position, introduce the drawer in the base cabinet making sure the drawer slide wheels are above the vanity slide wheels.
• Close the drawer completely and to ensure it has been properly installed, open it as far as possible. -
Hinge/Door Adjustment (If Applicable)
The door alignment was set in the factory, but it could have shifted during transit. If adjustment is needed, follow the instructions provided in the adjacent chart.
-
Drawer Front Adjustment (If Applicable)
• Remove decorative hardware from the drawer front.
• Hold drawer front in place and slightly loosen both alignment screws.
• Move the drawer front left, right, up or down to desired position for alignment.
• While holding the drawer front in place, tighten the alignment screws securely.
• Install the decorative hardware to the outside of the drawer front. -
Mirror Installation (If Included)
• Determine the desired location of the mirror. Use appropriate screws or wall anchors (not included) to hang mirror.
• Be sure the hanging hardware is rated to handle the weight of the mirror. The mirror weight is approximately 20 lbs.
Care and Cleaning
-
Vanity
To clean surface of doors or cabinet, use non-abrasive cleaners and or cleaning agents that do not contain solvents. -
Vanity Top
Your vanity top will remain in its original state if you maintain and clean it properly. Clean the surface with a glass cleaner or other household cleansers that are non-abrasive. Using abrasive cleansers will damage the surface. -
Mirror
Use non-abrasive cleansers only.
Warranty
LIMITED LIFETIME WARRANTY APPLICABLE TO USA AND CANADA | This product is warranted under normal use and service, to be free from defects in material and workmanship for the life of the product from the date purchased. During this warranty period, Seller will, free of charge, repair or replace the Product at its sole discretion. Proof of purchase, photo and the nature of the problem is required. Our warranty does not cover damage or failure caused by abuse, misuse, abnormal usage, faulty installation, improper maintenance or any repair other than those by Seller. There are no obligations or liabilities on the part of Seller for consequential damage arising out of or in connection with the use or performance of the product or any indirect damages included, but not limited to labor charges for installation or removal. This warranty gives you specific legal rights, and you may also have other rights that may vary from state to state. Further information regarding this warranty may be obtained without charge by contacting Customer Service. If any parts are missing or damaged, please send a copy of your receipt along with your inquiry to customercareWC@masterbrand.com.
For assistance call
Pour oftener de laid composer le
Para assistance, favor de llama al
(USA) 1-800-235-7747
(MX) 800-570-0319
March 2022
552586
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>