KLARSTEIN 10035262 Heat-N Beat Fireplace Heater Instruction Manual

HEAT‘N BEAT
Fireplace Heater
10035262 10035263

Note: This product is only suitable for well insulated spaces or for occasional use.
Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10035262

TECHNICAL DATA

PRODUCT DATA SHEET

only
Nominal heat output| Pm| 2.| kW| | manual heat charge control, with integrated thermostat| no
Minimum heat output (indicative)| Pm| 0.9| kW| | manual heat charge control with room and/or outdoor temperature feedback| no
Maximum continuous heat output| Pma xc| 2.| kW| | electronic heat charge control with room and/or outdoor temperature feedback| no
Auxiliary electricity consumption| | fon assisted heat output| no
At nominal heat output| el vi r| N/A| kW| | Type of heat output/room temperature control
At minimum heat output| elm| N/A| kW| | single-stage heat output and no room temperature control| no
In standby mode| | 0.00028| W| | Two or more manual stages, no room temperature control| no
| | with mechanic thermostat room temperature control| yes
| with electronic room temperature control| no
| electronic room temperature control plus day timer| no
| electronic room temperature control plus week timer| no
| Other control options (multiple selections possible)
| room temperature control, with presence detection| no
| room temperature control, with open window detection| no
| with distance control option| no
| with adaptive start control| no
| with working time limitation| no
| with black bulb sensor| no
Contact details| I Chal-Tec GmbH, Wallstral3e 16, 10179, Berlin, Germany

SAFETY INSTRUCTIONS

Note: Find a location for the electric heater that is protected from direct sunlight.
Do not plug the electric heater into the power outlet before you read all instructions.

• Please read all instructions carefully before operating the appliance and retain for future reference.

• Check that the voltage indicates on the data plate corresponds with that of the local network before connecting the appliance to the mains power supply.

• Never use the appliance unsupervised when in use.

• If you have to leave even for a short moment please stop the appliance.

• Keep out of reach of children and do not allow them to operate this appliance.

• Only use the appliance for domestic purposes and in the way indicated in these instructions.

• From time to time, check the cord for damage. Never use the appliance if the cord or any part of the appliance shows signs of damage.

• If the power cord is damaged, it must be replaced by the manufacturer, customer service or a similarly qualified person in order to avoid a hazard.

• Make sure that the power cord does not touch hot surfaces.

• In order to avoid overheating, do not cover the heater.

• Keep the appliance at least 15 cm from walls and any other thing, to permit good air circulation.

• Do not use the appliance outdoors

• Do not use if you have wet hands.

• Never use the appliance on or near hot surfaces.

• Never move the appliance by pulling the cord.

• Before cleaning the appliance, make sure it is unplugged from the power and that it is completely cooled.

• Do not clean the appliance with abrasive chemicals.

• Never use accessories that are not recommended or supplied by the manufacturer. It could cause danger to the user or damage to the appliance.

• Never route the main cable beneath the carpet.

• Never use the heater to dry clothes or any other similar items.

• The heater must not be located immediately below a socket outlet.

• This heater must not be used with an extension lead.

• Dot use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned
  incorrectly.

• In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

• Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.

• Children over the age of 8 and persons with reduced physical, sensory or mental capabilities or those with a lack of experience and knowledge may only use the appliance if they are instructed on how to do so by a person responsible for their safety, or if they are supervised and understand the hazards associated with the use of the appliance.

• Make sure that children do not play with the appliance.

• Cleaning and user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.

• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

• This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.

• To reduce the risk of fi re, keep textiles, curtains, or any other flammable material a minimum distance of 1 meter from the air outlet.

• This appliance is only suitable for well-insulated spaces or occasional use.

CAUTION
Risk of burns! Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

INSTALLATION

Accessories

Mounting the Castors

COMMISSIONING AND OPERATION

Once the appliance has been properly installed and connected to a grounded electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
Control Panel The heater controls are located right of the heater outlet.

Remote Control
Remote Control Battery Replacement

Replace with a CR2025 battery and follow the diagram at the back of the remote handset to install the new battery.
Note: Do not throw the old battery into the garbage can. Please recycle batteries through designated channels.

Operation by the Control Panel

0/I| Press this switch, the unit power on. When the O/I switch is turned off, all other functions are also stopped.
| Press this button to turn ON the fireplace. Press again to turn off the fireplace and the fan will continue to work for 60 seconds without heat.
| Press this button to change the flame colour. If you press the button once, the flames light up yellow. Press twice for yellow and blue flames. Press three times for blue flames.
| Press this button to change flame effect. Press again to decrease the flame intensity. There are 6 light intensities for your selection. The flame optics will go lower under the sequence of 6 – 5 – 4 – 3 – 2 – 1. Pressing the button
again will stop the flame effect.
| Press this button to the desired temperature. When the desired ambient temperature is reached, the heater will automatically stop heating. When the ambient temperature drops below the desired temperature 2 °C, the
heater will resume heating.
| Press this button to turn ON the fireplace. Press again to turn off the fireplace and the fan will continue to work for 60 seconds without heat.
| Press this button to toggle between the two temperature scales Celsius (°C) or Fahrenheit (°F). The current setting is displayed on the LED screen.
| Press this button for timer function. “0H” to “8H” is displayed on the LED screen. “0H” means there is no set running time and heater will run continuously. The displays “1H” to “8H” indicate the number of hours the
heater will operate before shutting off.
| Press this button to change flame effect. Press again to decrease the flame intensity. There are 6 light intensities for your selection. The flame optics will go lower under the sequence of 6 – 5 – 4 – 3 – 2 – 1. Pressing the button
again will stop the flame effect. By default the flame colour is yellow. Hold it for about 3 seconds to change flame colour. The flame colour will change under the sequence of yellow – yellow and blue – blue.
| Press up or down button to the desired temperature. When desired ambient temperature is reached, the heater will automatically stop heating. When the ambient temperature drops below the desired temperature 2 °C, the heater will resume heating

ADDITIONAL FEATURES

Play Music (via BT)
Open the BT function in your smartphone. Then search for the fireplace heater and connect. After connecting the BT speaker, open your music application in your phone and select your music.
Power Charging
Connect your mobile device to the USB port of the heater via a USB cable. You can charge your device.
WARNING
Risk of fi re! Please keep your smartphone, mobile device or cable away from the front air outlet (vent) of the heater.

CLEANING AND MAINTENANCE

WARNING
Risk of electric shock and fi re! Before attempting any cleaning and maintenance, switch the appliance off and disconnect it completely from the power supply. Maintenance should only be carried out by a qualified technician.

• Before cleaning any part of the appliance, turn off all controls and switches and unplug the power cord from the wall outlet. Wait until the appliance has cooled down completely.
  Cleaning Glass Panel

• Remove dust with a clean dry cloth.

• Remove fingerprints and other marks from the glass panel by using a clean damp cloth. Do not use abrasive cleaners or spray liquids on the glass surface.

• Metal and metal painted parts should be cleaned with clean damp cloth only.
  Do not use abrasive cleaners or spray liquids on these surfaces.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service. This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

DECLARATION OF CONFORMITY

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Berlin Brands Group UK Ltd
PO Box 1145
Oxford, OX1 9UW
United Kingdom
Hereby, Chal-Tec GmbH declares that the radio equipment type Heat ‘n Beat is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: use.berlin/10035262
For Great Britain: Hereby, Chal-Tec GmbH declares that the radio equipment type Heat ‘n Beat is in compliance with the relevant statutory requirements. The full text of the declaration of conformity is available at the following internet address: use.berlin/10035262

COMFORT
www.klarstein.com

References

• Klarstein | Your home. Your kitchen. Your style.
• Take-e-way GmbH | take-e-back | Elektroschrott Rücknahmesystem Onlinehandel

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>