KLARSTEIN 10036067 IceWind Max Air Cooler Instruction Manual

ICEWIND MAX
Air Cooler
10036067 10036068

Dear customer,
Congratulations on the purchase of your appliance. Please read the following instructions carefully and follow them to prevent potential damage. We accept no liability for damage caused by disregarding the instructions and improper use. Please scan the QR code to access the latest operating instructions and further information about the product.

https://use.berlin/10036067

TECHNICAL INFORMATION

delivery.

(1) The water consumption increases or decreases depending on the ambient humidity.

SAFETY INSTRUCTIONS

• Check the voltage on the rating plate before use. Only connect the appliance to sockets that correspond to the voltage of the appliance.
• Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.
• Do not place the cord under carpets. Do not cover the cord with small clothes, shirts or other similar elements. Place the cord away from traffic areas in order to avoid any risk of tripping over.
• Do not operate the appliance if the cable or plug is damaged.
• If the supply cord or plug is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Indoor use only.
• Do not cover the machine during use.
• Place the appliance on a stable flat horizontal surface. Make sure the appliance is in an upright position during use.
• Ensure the appliance is switched off before connecting to the main power supply.
• Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and mains supply connections.
• Do not leave this appliance unattended when it’s in use. Turn off and disconnect the appliance when you leave the room for an extended period.
• Switch off the appliance and unplug from the mains socket when not in use, before filling, cleaning or other maintenance.
• To disconnect the appliance, switch it “OFF”, and then remove the plug from the outlet. Do not pull the cord to disconnect the plug.
• Use the appliance only as described in this manual.
• Do not insert your fingers in the openings of the guard.
• Do not leave hair, tissue, tablecloths, clothes or curtains near all openings of the fan, they could be sucked into the fan and be taken within the internal moving parts that could cause injury or damage.
• Do not use the appliance in wet or damp locations such as bathrooms.
• Do not operate the appliance when it’s not mounted on its wheels or if it’s lying on the side.
• Make sure the cord is completely extended before use.
• When in operation, evaporative coolers moisturize the ambient air. Overhumidification of residential rooms should be avoided. Recommendation: 40-50 % relative humidity. Excessive humidity of the air can damage the home and cause health problems.
• The appliance may only be set up on water- and moisture-proof flooring materials (spilling some drops of water is unavoidable when the content of the tank is changed).
• With each and every change of tank content, completely remove residual water from the equipment. To prevent nucleation, remove residual water from the equipment and water tank every time after three days of use.
• This device can be used by children over 8 years of age and persons with limited physical, sensory or mental abilities or lack of experience and knowledge if they have been supervised or instructed in the safe use of the device and understand the dangers involved. Children must not play with the device. Cleaning and maintenance of the air cooler must not be performed by children without supervision.
• Keep new and used batteries away from children.
• If the battery compartment does not close securely, stop using the product.
• The batteries contain environmentally hazardous substances. They must be removed from the product before it is scrapped and disposed of safely.

WARNING
Danger of injury! Make sure that children do not swallow the battery. If the button cell battery is swallowed, it can cause severe internal burns in only 2 hours and lead to death. If you think that batteries may have been swallowed, consult a doctor immediately.

Special notes on use

• Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
• Do not permit the area around the humidifier to become damp or wet. If dampness occurs, turn the output of the humidifier down. If the humidifier output volume cannot be turned down, use the humidifi er intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to become damp.
• Unplug the appliance during filling and cleaning.
• Never leave water in the reservoir when the appliance is not in use.
• Empty and clean the humidifier before storage. Clean the humidifier before the next use.

DEVICE OVERVIEW AND REMOTE CONTROL

CONTROL PANEL

GETTING STARTED

1. Open the packaging and remove the device. Make sure that all items included in the scope of delivery are complete.
2. Place the device horizontally on a stable surface. Do not tilt the unit before use. Before starting the device, make sure that the voltage of the socket used corresponds to the voltage specified on the type plate of the device.

Adding water

• First remove the water tank from the machine. Before removing the water tank, make sure that all the residual water from the pump system has already flowed back into the water tank to prevent the water from flowing out of the appliance.
• Observe the minimum and maximum markings in the water tank.
  Note: Make sure that the water level is always between the two marks and never exceeds the maximum mark, otherwise the water could overflow. Before filling with water, remove the cardboard attached to the left side of the water tank.

OPERATION

Switching on

1. After plugging the power cord into the wall outlet, press the button to switch the device from standby mode to operating mode.
2. The factory default setting is fan speed 1 in normal mode.

Fan speed
• The unit has 4 different speed settings.
• While the unit is on, press the SPEED button to adjust the fan speed. Each time the SPEED button is pressed, the fan speed is increased by one step. If you press the button again after the highest speed is reached, the device will start again at the lowest speed level, etc.

Timer

1. Automatic switch-off
   • While the unit is on, press the TIMER/PRESET button to enter the timer standby setting. If you press this key several times, you can set the time until the unit automatically switches to standby mode in the following sequence: 1h > 2h > 3h > … > 15h > Cancel timer setting. The corresponding indicator lamp lights up.
   • As soon as the time you have set in the timer has expired, the device automatically switches to standby mode.
   • If you keep the TIMER/PRESET button pressed, the time can be set faster.

2. Automatic switch-on
   • If you press the TIMER/PRESET button in standby mode, you can set the time until the unit switches on automatically. If you press this key several times, you can set the time until the unit automatically switches on in the following sequence: 1h > 2h > 3h > … > 15h > Cancel timer setting. The corresponding indicator lamp lights up.
   • As soon as the time you have set in the timer has elapsed, the device will switch on automatically.
   • If you keep the TIMER/PRESET button pressed, the time can be set faster.
   Mode
   After switching on the unit, press the MODE button. By pressing several times, the unit switches between the modes: General (normal) – Natural (natural) – Sleep (snooze mode). The corresponding indicator lamp lights up.
   • General: The wind is continuously emitted from the device at the same speed.
   • Natural: In this mode, depending on the program set, the wind occurring in nature is simulated. The wind speed alternates back and forth between strong and weak.
   • Sleep: The fan speed is automatically reduced to low after some time, depending on the set program.
   Swing function
   In operating mode, press this button to switch on the oscillation function. Each time you press it once, the functions are called up in the following order: Swing Up and Down > Swing Left and Right > Swing OFF > Swing Left and Right > Swing Up and Down > Swing OFF.
   Humidification
   When this button is pressed in the operating mode of the unit, the humidification function can be activated or deactivated. The corresponding indicator lamp lights up.
   Note: Check the water level in the water tank before activating the humidification function. If the water level is below the minimum mark, the water must be topped up.
   Lower water level
   If there is not enough water in the water tank, the unit automatically stops operating in humidification mode. The humidification indicator or the “Low water level” indicator flashes. Fill the water tank. Then restart the humidification function.
   Screen illumination
   If no button is pressed within 40 seconds, the screen illumination is dimmed by 50 %. Press any button to make the screen fully lit again.
   Memory function
   This unit has a memory function. When the unit is put into standby mode, the previously set function is saved. When you switch the unit on again, it will then automatically start in the previously saved function.
   Automatic standby mode
   If no button is pressed within 15 hours, the unit is automatically set to standby mode.
   Remote control
   The buttons on the remote control corresponding to the buttons on the unit. When using the remote control, make sure that the infrared transmitter of the remote control is pointed at the infrared receiver of the unit. There must be no obstacles between the remote control and the device. Remove the batteries from the remote control if it will not be in use for a long period of time.
   Note: There is no heating function.
   Cooling pack
   Do not open the ice container under any circumstances. The contents of the ice container are not suitable for consumption. Place the ice containers in the freezer compartment of your refrigerator or in a freezer for at least four hours before use (see picture).

Place the ice container in the water tank of the appliance. To do this, first pull the mains plug out of the socket. Then pull out the water tank at the back of the machine. Place the ice container in the marked side of the water tank to ensure that it can be pulled out properly.
Make sure that the water level does not exceed the maximum mark even after inserting the ice container. To remove the ice container, pull out the water tank and remove the ice container. There are 2 ice containers included in the delivery, which can be used on a rotating basis.

CLEANING AND CARE

Storage
Empty the water from the water tank if you will not be using the device for a long period of time. Then let the unit run in “General” mode for a while to dry the wet curtain completely. Then cover the unit or store it in its original packaging.
Cleaning
If you have already been using the appliance for a long period of time, the water tank, the water tank filter, the wet curtain or the wet curtain filter may become blocked by dust, limescale or other residues. This can negatively affect the air volume or the cooling effect. It is recommended to clean the appliance at least once every 2 weeks. Before cleaning, the main plug must be disconnected from the socket.

1.  First remove the wet curtain from its holder. To do this, pull the clips on both sides of the wet curtain holder slightly outwards. The wet curtain and its filter can then be removed. Clean the wet curtain with clean water and then dry it completely before putting it back in place (see figure 1).
2. To remove the filter, first pull out the water tank. You can then pull out the filter (see figure 2).
3. Clean the filter with a soft brush or cloth. Then rinse the filter with clean water.

|
---|---

Water tank cleaning
Pull out the water tank directly for cleaning.
Water channel cleaning
Once the water tank has been pulled out, you can check whether there is any residual water in the water channel. If this is the case, absorb the water with a dry cloth.

Housing cleaning

1.  Wipe the housing with a damp cloth. Do not rinse the housing directly with water.
2.  Do not clean the housing with an aggressive cleaning agent.
3. After cleaning, put all the accessories back into the appliance in reverse order.
   Note: To replace the wet curtain, press its bottom into the opening provided (see figure 3). Then press down the brackets of the holder with your hand. Do not put the wet curtain back into the unit unless the filter has been installed. Failure to do so may result in damage to the unit.
   

TROUBLESHOOTING

the power plug securely into the wall socket.
The nebulizer unit
has not been installed correctly.| Install the nebulizer unit correctly.
The unit is switched off.| Switch the device on.
The wiring in the unit has come loose.| Contact a specialist company for repairs.
The humidifier does not work / The pump makes strange noises.| No water in the water tank or the water level is below the MIN mark.| Switch off the device and fill water into the water tank.
The filter screen of the submersible pump is clogged.| Clean the filter screen.
The water outlet hole of the nebulizer unit is blocked.| Clean the nebulizer unit.
The pump or the wiring in the unit has come loose.| Contact a specialist company for repairs.
Abnormal noises.| Deposits in the nebulizer unit.| Remove the nebulizer unit and clean the components.
Loose fan blades or motor damage.| Contact a specialist company for repairs.

DISPOSAL CONSIDERATIONS

If there is a legal regulation in your country regarding the disposal of electrical and electronic equipment, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of this product in accordance with the regulations, you protect the environment and the health of those around you from negative consequences. For information on the recycling and disposal of this product, contact your local government or household waste disposal service.
This product contains batteries. If there is a legal regulation in your country regarding the disposal of batteries, the batteries must not be disposed of in the household waste. Consult your local regulations for the disposal of batteries. By disposing of this product in accordance with the regulations, you protect the environment and the health of those around you from negative consequences.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
Importer for Great Britain:
Berlin Brands Group UK Ltd
PO Box 1145
Oxford, OX1 9UW
United Kingdom

COMFORT
   www.klarstein.com

References

• Klarstein | Your home. Your kitchen. Your style.
• Take-e-way GmbH | take-e-back | Elektroschrott Rücknahmesystem Onlinehandel

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>