SCOSCHE Boomcan MS Portable Speaker User Guide
- June 5, 2024
- Scosche
Table of Contents
SCOSCHE Boomcan MS Portable Speaker
CHARGING
Use the included cable (A) to connect BoomCan MS to a USB-C charger or power source (not included). The LED indicator (B) wll illuminate red while charging and shut off when charging is complete. LED blinks red with a sound prompt when battery level falls below 10%.
PAIRING
Power On/0ff & Pairing (A):
Press & hold MFB for 3 seconds. The LED indicator will blink white and an
audio prompt will sound. Pairing is initiated when speaker is powered on, and
will display on mobile device as “BoomCan MS” An audio prompt indicates
successful pairing.
Dual Pairing (B):
Tap MFB twice on 1st speaker and an audio prompt will sound, then power on 2nd
speakerAn audio prompt will indicate successful pairing. Play/Pause: Tap MFB
once to play or pause device Auto Reconnect: When powered on speaker will
automatically connect to last paired device.
INSTALlATION
- A. iPhone 12 or Later* (with optional MagSafe Case)
- B. iPhone 12 or Later* (without Case)
CHARGING
- Use the included cable (A) to connect BoomCan MS to a USBC charger or power source (not included}.
- The LED indicator(B) will illuminate red while charging and shut off when charging is complete. LED blinks red with a sound prompt when batterv level falls below 10%
SPECIFICATIONS
Music: Upto5 hrs
Charge Time: 1.5 hrs
Battery: 500 mAh
Charge Input: 5V=500mA
Range: Up to 33 ft. (10 m)
Waterproof Rating: IP67
Bluetooth v5.3
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modifications to this product not expressly approved by the party responsible for compliance Could void the user’s authority to operate the equipment This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. f this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/V technician for help.
Scosche Industries
I SSO Pacific Avenue
Oxnard, California 93033
Phone 800 3634490 xi/ 805-486-44S0 xi
www.scosche.com
©2022 Scosche Industries