KOLINK Unity Nexus ARGB Midi Tower Case User Manual

KOLINK Unity Nexus ARGB Midi Tower Case User Manual

1. ACCESSORY PACK CONTENTS

2. PANEL REMOVAL

• Left Panel – Unscrew the two thumbscrews and slide the glass panel backwards.
• Right Panel – Unscrew the two thumbscrews and slide off.
• Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release.

3. MOTHERBOARD INSTALLATION

• Align your motherboard with the chassis to locate where the stand-offs should be installed.
  Once done, remove the motherboard and fasten stand-offs accordingly.

• Insert your motherboard I/O plate into the cutout at the rear of the case.

• Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.

• Use the provided motherboard screws to attach your motherboard to the chassis.

4. POWER SUPPLY INSTALLATION

• Place PSU in the bottom rear of the case, within the PSU shroud.
• Align the holes and secure with screws.

5. GRAPHICS CARD/PCI-E CARD INSTALLATION

VIDEO CARD/PCI-E CARD INSTALLATION

• Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)

• Carefully position and slide your PCI-E card into place,
  then secure with the add-on card screws supplied.

• If mounting vertically, attach the provided vertical GPU bracket to the PSU shroud, secure
  your Kolink PCI-E riser cable to it (sold separately) and attach the cable to the motherboard.

Remove the rear PCI-E slot covers as necessary, then carefully position your PCI-E card, slot into the PCI-E riser mount and secure with the add-on screws supplied.

6. 2.5″ SDD INSTALLATION (R)

• Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drive and then screw back into place.

7. 2.5″ SDD INSTALLATION (R)

• Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.

8. 3.5″ HDD INSTALLATION

Place the 3.5″ HDD into/on top of the HDD bracket and screw in if required.

9. TOP FAN INSTALLATION

• Remove the dust filter from the top of the case.
• Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
• Replace your dust filter once secured.

10. FRONT/REAR FAN INSTALLATION

• Align your fan to the screw holes on the chassis and secure with screws.

11. WATERCOOLING RADIATOR INSTALLATION

12. I/O PANEL INSTALLATION

• Carefully check the labelling of each connector from the I/O panel to identify their function.
• Cross reference with the motherboard manual to locate where each wire should be installed,
  then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>