KOLINK Observatory Y ARGB Midi Tower Case User Manual

KOLINK Observatory Y ARGB Midi Tower Case User Manual

ACCESSORY PACK CONTENTS

PANEL REMOVAL

• Left Panel – Pull the tab to open the hinged glass panel and lift off the hinges
• Right Panel – Unscrew the two thumbscrews and slide off.
• Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release.
  

MOTHERBOARD INSTALLATION

• Align your motherboard with the chassis to locate where the stand-offs should be installed.
  Once done, remove the motherboard and fasten stand-offs accordingly.

• Insert your motherboard I/O plate into the cutout at the rear of the case.

• Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.

• Use the provided motherboard screws to attach your motherboard to the chassis.
  

POWER SUPPLY INSTALLATION

• Place PSU in the bottom rear of the case, within the PSU shroud.
• Align the holes and secure with screws.
  

GRAPHICS CARD/PCI-E CARD INSTALLATION

• Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
• Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
• Graphics card can also be mounted vertically using the Vertical GPU bracket & riser cable kit (sold separately)
  

2.5″ SDD INSTALLATION (R)

• Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drive and then screw back into place.
  

2.5″ SDD INSTALLATION (R)

• Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
  

3.5″ HDD INSTALLATION

• Place the 3.5″ HDD into/on top of the HDD bracket and screw in if required.
  

TOP FAN INSTALLATION

• Remove the dust filter from the top of the case.
• Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
• Replace your dust filter once secured.
  

FRONT/REAR FAN INSTALLATION

• Align your fan to the screw holes on the chassis and secure with screws.
  

WATERCOOLING RADIATOR INSTALLATION

• Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
  

I/O PANEL INSTALLATION

• Carefully check the labelling of each connector from the I/O panel to identify their function.
• Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>