KOLINK ARGB Observatory HF Mesh Midi Tower Case User Manual
- June 13, 2024
- KOLINK
Table of Contents
- KOLINK ARGB Observatory HF Mesh Midi Tower Case User Manual
- ACCESSORY PACK CONTENTS
- PANEL REMOVAL
- MOTHERBOARD INSTALLATION
- POWER SUPPLY INSTALLATION
- GRAPHICS CARD/PCI-E CARD INSTALLATION
- 2.5″ SDD INSTALLATION (REAR)
- 2.5″ SSD INSTALLATION (REAR)
- 3.5″ HDD INSTALLATION
- TOP FAN INSTALLATION
- FRONT/REAR FAN INSTALLATION
- WATER COOLING RADIATOR INSTALLATION
- I/O PANEL INSTALLATION
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
KOLINK ARGB Observatory HF Mesh Midi Tower Case User Manual
\
ACCESSORY PACK CONTENTS
- **Motherboard/SSD Screws x14
**
- **Motherboard Stand-off x3
**
- **PSU Screw x8
**
- **3.5” Drive Screw x4
**
- **Add-on Screw x2
**
PANEL REMOVAL
- Left Panel – Pull the tab to open the hinged glass panel and lift off the hinges
- Right Panel – Unscrew the two thumbscrews and slide off.
-
- Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips releas
MOTHERBOARD INSTALLATION
- Align your motherboard with the chassis to locate where the stand-offs should be installed.
- Once done, remove the motherboard and fasten stand-offs accordingly.
- Insert your motherboard I/O plate into the cutout at the rear of the case.
- Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
- Use the provided motherboard screws to attach your motherboard to the chassis.
-
POWER SUPPLY INSTALLATION
- Place PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
VIDEO CARD/PCI-E CARD INSTALLATION
- Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
2.5″ SDD INSTALLATION (REAR)
- Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drives and then screw back into place.
2.5″ SSD INSTALLATION (REAR)
- Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
3.5″ HDD INSTALLATION
TOP FAN INSTALLATION
- Remove the dust filter from the top of the case.
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
- Replace your dust filter once secured.
FRONT/REAR FAN INSTALLATION
- Align your fan to the screw holes on the chassis and secure with screws.
WATER COOLING RADIATOR INSTALLATION
- Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
I/O PANEL INSTALLATION
- Carefully check the labelling of each connector from the I/O panel to identify their function.
- Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>