KOLINK B084C8BZQD Void Rift Midi Tower Case User Manual
- June 4, 2024
- KOLINK
Table of Contents
KOLINK B084C8BZQD Void Rift Midi Tower Case
ACCESSORY PACK CONTENTS
PANEL REMOVAL
FRONT/SIDE PANEL REMOVAL
- Take off the front panel by pulling carefully from the bottom of the panel.
- Remove the left side panel by removing the 4 thumbscrews and lift the glass side panel away from the case.
- Remove the right side panel by removing the two rear thumbscrews and sliding the panel backwards.
Installations
MOTHERBOARD INSTALLATION
- Align your motherboard with the chassis to locate where the stand-offs should be installed. Once done, remove the motherboard and fasten stand-offs accordingly.
- Insert your motherboard I/O plate into the cutout at the rear of the case.
- Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
- Use the provided motherboard screws to attach your motherboard to the chassis.
POWER SUPPLY INSTALLATION
- Place PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
- Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
- If mounting vertically, attach the provided vertical GPU bracket to the PSU shroud, secure your Kolink PCI-E riser cable to it (sold separately) and attach the cable to the motherboard. Remove the rear PCI-E slot covers as necessary, then carefully position your PCI-E card, slot into the PCI-E riser mount and secure with the add-on screws supplied.
2.5″ SSD INSTALLATION (REAR)
- Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drive and then screw back into place.
- Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
3.5″ HDD INSTALLATION
- Place the 3.5″ HDD into/on top of the HDD bracket and screw in if required.
TOP FAN INSTALLATION
- Remove the dust filter from the top of the case.
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
- Replace your dust filter once secured.
FRONT/REAR FAN INSTALLATION
- Align your fan to the screw holes on the chassis and secure with screws.
WATERCOOLING RADIATOR INSTALLATION
- Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
I/O PANEL INSTALLATION
- Carefully check the labelling of each connector from the I/O panel to identify their function.
- Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time. Please ensure they are installed in the correct polarity to
avoid non-function or damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>