KOLINK Observatory HF Glass ARGB MIDI Tower Case User Manual
- June 13, 2024
- KOLINK
Table of Contents
- ACCESSORY PACK CONTENTS
- PANEL REMOVAL
- MOTHERBOARD INSTALLATION
- POWER SUPPLY INSTALLATION
- GRAPHICS CARD/PCI-E CARD INSTALLATION
- 2.5″ SDD INSTALLATION (REAR)
- 2.5″ SSD INSTALLATION (REAR)
- 3.5″ HDD INSTALLATION
- TOP FAN INSTALLATION
- FRONT/REAR FAN INSTALLATION
- WATER COOLING RADIATOR INSTALLATION
- I/O PANEL INSTALLATION
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
KOLINK Observatory HF Glass ARGB MIDI Tower Case User Manual
ACCESSORY PACK CONTENTS
- **Motherboard/SSD Screws x14
**
-
Motherboard Stand-off x3
-
PSU Screw x8
-
3.5” Drive Screw x4
-
**Add-on Screw x2
**
PANEL REMOVAL
- Left Panel – Pull the tab to open the hinged glass panel and lift off the hinges
- Right Panel – Unscrew the two thumbscrews and slide off.
- Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips releas
MOTHERBOARD INSTALLATION
-
Align your motherboard with the chassis to locate where the stand-offs should be installed.
Once done, remove the motherboard and fasten stand-offs accordingly. -
Insert your motherboard I/O plate into the cutout at the rear of the case.
-
Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
-
Use the provided motherboard screws to attach your motherboard to the chassis.
POWER SUPPLY INSTALLATION
- Place PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
VIDEO CARD/PCI-E CARD INSTALLATION
- Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
2.5″ SDD INSTALLATION (REAR)
- Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drives and then screw back into place.
2.5″ SSD INSTALLATION (REAR)
- Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
3.5″ HDD INSTALLATION
TOP FAN INSTALLATION
- Remove the dust filter from the top of the case.
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
- Replace your dust filter once secured.
FRONT/REAR FAN INSTALLATION
- Align your fan to the screw holes on the chassis and secure with screws.
WATER COOLING RADIATOR INSTALLATION
- Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
I/O PANEL INSTALLATION
- Carefully check the labelling of each connector from the I/O panel to identify their function.
- Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.
Read User Manual Online (PDF format)
Loading......